Quantcast
Jump to content

Recommended Posts

Posted

can someone tell me which side the neutral and reverse switch are on a 1986 honda trx 200 The service manual does not say which side, i got the lites pulled out and looked at them and i think the switches are bad. i just don't know which side they are on , the photo in the book just shows how it looks after a cover is off and not which side its on.i would just like to know so i don't have to take stuff off that i don't have to.  thanks for any info on this.......

Posted

Remove the junction box cover. Disconect the neutral switch wire connector . Check for continuity between the light green/red wire terminal and ground. The switch is good if there is continuity with the transmission in neutral.

For the reverse switch check continuity between gray and ground good if you have continuity with the transmission in reverse.

Poor photo from service manual.

IMG_5472.thumb.jpeg.be750f24b91a60dfc27d133283e9d55a.jpeg

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Forum Topics

    • By cavry
      O3 sat a while. Engine is running fine. I got it into neutral, did some general tune-up and cleaning then pulled the shifter pedal up and it locked up and will not release into neutral again.  Does anyone have experience with this problem?  Thanks for looking and any help.
      Cavry
    • By Cj Winds
      I have a 2009 Honda Rancher TRX420FA with shifting problems.
      Usually it shifts ok when cold but after couple minutes it will stop shifting with no codes.
      The 1st shift clutch oil pressure when in first gear is 74psi. The 2nd shift clutch oil pressure when in second gear is 74psi.
      The 1st shift clutch oil pressure when in neutral is zero. The problem is when the tranny is in neutral the 2nd shift clutch pressure starts around 10-15psi and builds to 20psi. Is this normal?
    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By flyinbrian365
      View File 2023 Yamaha RMAX4 Wolverine 1000 service manual
      Factory service manual
      2023 Yamaha RMAX4 Wolverine service manual
      Submitter flyinbrian365 Submitted 06/08/2026 Category Yamaha UTV  
    • By flyinbrian365
      View File 2021-22 Yamaha RMAX4 1000 Wolverine service manual
      Factory service manual
      2021-22 Yamaha RMAX4 1000 Wolverine service manual
      Submitter flyinbrian365 Submitted 06/08/2026 Category Yamaha UTV  
×
×
  • Create New...