Quantcast
Jump to content


Muzzy Digi-Tune available for the 2009 Kawasaki Teryx


Recommended Posts

SXSMuzzysDigitune-1-728694.jpg

Taking air/fuel tuning to the next level, the Muzzy Digi-Tune uses the latest technology to provide one of the easiest and most accurate methods of tuning your fuel injected quad.

Every Muzzy Digi-Tune comes pre-programmed and optimized for each model. There is no mapping or re-mapping necessary. Adjustments for elevation and/or modifications can be done "on-the-fly" using three buttons on the faceplate.

WHY IT'S BETTER: The Digi-Tune is a load based fuel adder which works with the factory ECU. The Digi-Tune's simple push button interface and powerful load based technology renders complex table-based throttle position and RPM re-mapping systems a thing of the past.

LOAD BASED TUNING: The Digi-Tune ushers in the latest in tuning science – gone is the old throttle position and RPM (Alpha-N) based tuning, replaced by a powerful and highly effective LOAD BASED tuning methodology. Load based tuning is superior to old school systems because different gears place different loads on the engine. RPM and throttle position based systems cannot tell the difference between first or fifth gear. The Digi-Tune knows the difference and adds the proper amount of fuel for every gear, every situation.

2009 Kawasaki Teryx Digitune

Part #: 0015-00081

MSRP: $245.95

More information: http://www.muzzys.com/RUV/RUV_Digitune.html

Muzzys

Website: http://www.muzzys.com

Phone: 541-385-0706

More...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gwbarm
      I generally use Non Ethynol fuel in all my small engines. I just got back from the gas station and that fuel has really increased in price since last year, I will continue to use it, even though its north of 1.00 a gallon more. That seems minor compared to cleaning and repairing carbs every year. 
      I was just curious as to what others are doing in regard to gas in their quads, i know a lot of the newer ones are fuel injected which shouldnt pose a problem, but i have had lots of problems with rust and jell forming in carbs when using ethynol fuel.
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • By jatho
      Has anyone else had an issue on older king quads where the oil would leak from the top of the head (due to a failed gasket) and drip onto the hot exhaust? Mine got so hot one time it caught fire. Just wondering if this is a common issue, as I've seen the same thing happen on multiple bikes that were the same model. 
    • By mkibbe
      My 2014 750 king quad stalls sometimes when I touch or turn the handlebars,the problem has gotten worse,my machine has 475 miles and is only trail ridden,I have a new factory battery and i have 14.2 volts when the quad is running and 13.3 on the battery when not running,also using a multimeter there is no change in volts when turning the bars until it does stall,If I pull the 40 amp power steering fuse it will not stall.......I've been told its the ECU,Hate to buy one if thats not the problem,but its kinda leaning towards that,,,,,need some opinions.

×
×
  • Create New...