Quantcast
Jump to content

Eton Low Compression 90cc Thunder 2001


Recommended Posts

I have an Eton Thunder 90CC Compression test is 45psi. I have done the following:

1. New Top End

2.New Crank Seals R&L

3.New Air Box And filter.

4. Leak down test ( Found Reed valve gasket Leaking repaired leak.)

5 cleaned carb.

Still at 45 PSI any help to help diagnosis would be appreciated.

Terry

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By jsamuels496
      Have had the carb apart twice now and can"t find any obvious problems. but if I leave the fuel on it floods the float bowl and leaks out the overflow. What should I be checking?
    • By Freddie
      My first quad and I have a problem. I have a Kawasaki Bayou 300 1997. When I start it. It will go on high idle for about ten seconds before it goes down to low idle. It does this even when I don't touch the throttle or the choke.
      Also, when I give it some throttle and let go. It will come back to fast idle for about ten seconds before it comes down to slow idle. Therefore I have to wait for it to slow up before I can shift. The throttle linkage drops right back to the stop on the carb buy the rpms stay up for a while. If you have any ideas what might be wrong please let me know. thank you Fred
    • By dalton7545
      ive had an account for years.   cand dowload a manual tho   havent posted enought so here is a post
    • By Ajmboy
      If you live in New York, Come and join my group here on quadcrazy! Go to http://www.quadcrazy.com/groups/?id=1
    • By lester
      I picked up a 2000 Big Bear 400 4X4 that was sitting around that I know nothing about. It will not start. I do have a red light when in reverse. When I take it out of reverse, I do not get a green neutral light, and when I push the start button the red oil light comes on but there are no noises, nothing else happens. How do I test the neutral switch and/or bypass it to see if I can get it to at least crank? And does anyone have other suggestions for me to try?
×
×
  • Create New...