Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
New member here,
I have searched here and other places and have not found an answer to my problem. As the title says I have a 2014 420 Rancher that recently started having an issue were the revs before the clutch engages.
I have checked the oil level (per the service manual) and replace the Valvoline ATV 10w40(less than 5 hours) with 10W30 GN4 for good measure. I have used the "pin" method to pull a DTC. I shows a 8-1 which is a TPS error. This makes some sense, as if the computer doesn't read throttle position correctly, it could have this symptom. I have checked the source voltage, and tested the TPS off the quad with a Fluke and a power supply at 5v. It is smooth and does not seem to be a bad sensor. I am confused by the DTC, because the PS light blinks the code, not the check engine light. However, there are no PS codes of that value. This condition appeared after a couple days of driving in the cold (~32°) and driving though some water/bogs.
A couple questions. First has anyone seen this issue, and do you have any suggestions? I have followed the troubleshoot right up to the point of replacing the ECU, which I don't seem to have one on the shelf :)
Second, anyone used a OBDII reader with an a 4pin adapter to pull codes? If so, what system do you use?
Beyond the rev issue, the quad runs and starts perfectly and when it decides, the clutch grabs tight (no slipping)
Can I put 75w140 gear oil in my Suzuki lt230ge (shaft drive)
Hi. I'm owning 2014 Sportsman Forest 850. Due to operation there is a problem with the decals and I would like to update them. But, as it turned out, this model is rare and finding the necessary stickers is a very difficult task, especially considering that the part of the decals set that I'm looking for is no longer produced - number 2 on the pic below with part number 7179065.
I've tried to contact Polaris support asking them to sell me this decals or send image in any possible format to print by myself but unfortunately no luck and it's sad, because I have owned various models of Polaris for over 10 years and a fan of this manufacturer.
Perhaps someone can send graphic files so I can print the stickers myself or show me how to get them?
Or is there another solution to this problem? Small fresh decals make the ATV look completely different.
Thank you in advance for any help or idea.
Just picked up a 2003 Yamaha Kodiak 450 ATV. Doesn't run and it's been sitting out in a field for a while faded bodywork, seat's a mess, dead but it rolled so I figured for $100 what the hell, SOLD! I have no idea what could be wrong with it, first thing I guess is hook up a battery and see what happens. I'll likely be back here with questions for the forums collective experience. Live in the Santa Cruz Mts and sure could use a little work horse like this quad to haul stuff up and down my steep property. Thanks in advance.
Hope you all have a great Thanksgiving!
Similar Tagged Content
Recently Browsing 0 members
- No registered users viewing this page.