-
Popular Now
-
-
Similar Forum Topics
-
By LMI
Hi all. New to the forum & quads. Seems like a great place full of info.
I just recently picked up a 2005 Suzuki KingQuad LTA700. I need a battery. I've been reading up on conventional vs AGM types. I have a Royal Distributing and Canadian Tire. RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140. Neither of these is the type from the manual FTZ16-BS.
from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS. How much does this make a difference for nearly x2 the cost?
And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
-
By HoldenBoy
Hi all,
Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley. -
By HeWasRidinDirty
The one I need to replace has a 2 wire plug coming out of it. Searching eBay I see tons of them with only 1 wire . WTH???
-
By crankin
I have a 1997 Yamaha Big Bear 350 4x4. It used to start right up. Then all of a sudden it wouldn't crank. I have a schematic for it so I started tracing the problem. I had no power at the starter solenoid. According to the schematic the power comes from the neutral switch and through the starter circuit cut out relay. I cannot locate the cut out relay on this machine.. If I apply power to the relay it will crank with the start button.
The neutral switch is hard to get to with all the brackets on this thing. I did find out from all my research that if I apply the rear brake lever it will start.
Does anybody know if the cut out relay exists and where it might be found?
-
By tds7
The battery on my Big Bear drops completely down in the battery compartment nothing sticks up to grip too, plus there is only 1/8" clearance along the sides, no way to get a grip on it to pull up out of battery compartment. I thought about putting a piece nylon strap under the battery and leaving enough up each side to give me something to pull it up out ff the battery compartment or using a big zip tie around the battery.
Any others have any ideas or have had this issue.
-
COMMUNITY SECTIONS
ATV FORUMS
QUADCRAZY MEMBERSHIP
Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.