Quantcast
Jump to content

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Louznmemind
      (Question is at the end if you want to skip my blabbering) I got this unbelievably well taken care of Grizzly 350 in for a carb clean, it belongs to an elderly couple that bought it brand new in '07. Apparently whoever has been doing their oil changes for them never checked the air filter..
      Obviously it got debris in the carb, it would still run but only idle with slight choke. I've taken it apart and cleaned it, have new o rings, gaskets, etc. As far as the mixture screw is concerned, I'm assuming I obviously need to remove the plug. I'm mainly a lawn equipment guy, I've worked on slide carbs in the past but never an unmolested one with the plug still intact. I hate to mess with it as the carb had very little debris but I'm sure the o ring needs to be replaced at minimum. Finally, the question: what's the best way of removing the plug? I DO NOT want to mess up this carb..



    • By nduray3
      Is there anyway to make the pilot screw accessible on a 1996 Suzuki king quad 
    • By Ryan Menard
      Hi all,
      I have the strange issue where the float bowl drain screw on our ‘16 outlaw 50 is leaking by and letting fuel drain out of the tube.  It is not the overflow tube.  I have taken the carb apart to clean as well as taken the screw out and reinserted it but it still leaks by.  I can’t seem to find the screw alone for sale, all I can find is the whole float bowl for $100.  I would rather try a new screw first.  
      Does anyone know what screw will work in the factory carburetor and/or where to purchase one from?
      Thanks.
    • By Bennett
      I have this taotao quad four-wheeler all of a sudden my daughter was riding it and the clutch got loose and she can't change gears. I've tried tighten it up I've watched videos. I'm a single mother/father so I don't know what else to do to tighten it up can someone help me . This is the clutch. 

    • By Leftysdad
      Big bear 400 idle screw doesn't turn....any advice in how to get it unstuck...when I turn it with a screwdriver,  the whole cable turns,  thanks in advance guys 

×
×
  • Create New...