Quantcast
Jump to content

Recommended Posts

Posted

I got a 91 king quad 300 that i got from a guy for 900$ and it was running great when i got it, but now both front CV joints went after having it in 4WD for only a couple times. Now i found that it need a starter clutch also and then a jet in the carb that doesnt come in the carb kit either... I replaced the valves and honed out the cylinder and the piston was in great shape so i didnt touch that. But im wondering if it is worth fixing for everything that is wrong with it. I do the fixes myself however. This thing has amazing power in super low and i just dont want to give it up but idk what to do?????:aargh:

Posted

shop around the diff part sites and see how much all this will cost and then make a decision if you want to put that much into it. maybe consider finding another bike for parts. that might be cheaper, but not guaranteed all good parts ... still a good bike, but have to consider 20+ years of wear and tear

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By crankin
      I have a 1997 Yamaha Big Bear 350 4x4. It used to start right up. Then all of a sudden it wouldn't crank. I have a schematic for it so I started tracing the problem. I had no power at the starter solenoid. According to the schematic the power comes from the neutral switch and through the starter circuit cut out relay. I cannot locate the cut out relay on this machine.. If I apply power to the relay it will crank with the start button.
      The neutral switch is hard to get to with all the brackets on this thing. I did find out from all my research that if I apply the rear brake lever it will start.
      Does anybody know if the cut out relay exists and where it might be found?
    • By quadnut20
      Just picked up a 2025 Yamaha Kodiak 700 fixing to do a EPI Clutch mod to it since I dropped bigger tires on it !! Air box , exhaust , and programmer next ! 

    • By TomJulio
      I recently noticed my Fourtrax 2WD has 4WD wheels installed on the front.  The back spacing is significantly different than 2WD wheels and they are almost touching the strut springs and the tires actually do touch the springs..   So far, no luck locating 2WD wheels to correct this issue. 
×
×
  • Create New...