Quantcast
Jump to content


1994 LT-F4WDX K.Q. - Rebuild Advice


Recommended Posts

im BRAND new to thew ATV world and i was given a free 1994 king quad. the thing is, the engine runs, but is verrryy rough. it starts fine, idles well, and revs fine too, but only for a while. then when given gas the engine bogs down and barely runs, puffs out lots of smoke and smells of oil and some times quits completely. then it will go back to running fine. and back and forth...the machine had been sitting in the guys yard for 2 years. also, gas is in the oil. i have no idea where it is coming from..

already i have taken the carb out and am in the process of rebuilding that..i also added a new air filter(the old one was black with oil and very chewd up)and spark plug(the old plug was black and charred as well.)

anything helps! THANK YOU

Link to comment
Share on other sites

you're on the right track, probably all carb problems. gas in oil may be from bad needle and float if the petcock was left on or shot. running crappy and smoking from dirty carb and old gas. check the crank vent lines too going to the carb breather box. put a film of oil on your new air filter too. i'll look to see if i have a manual for your bike ....

Link to comment
Share on other sites

When you change the oil and filter on those small Suzuki motors about 1/3 of a quart remains in the bottom of the crankcase. I was told you have to split the case to drain that last .3 qts. I think I came up with a better method. With a frame hoist or engine hoist or two big friends lift the front of the ATV up until the bike is vertical. That remaining oil will drain out the filler hole. Be sure to shut the fuel petcock before doing it or gas will run out the top of the carb because you are unseating the neeedle valve. Mine had water in the oil and I changed it 3 times, but it still remained grey. After lifting it once the oil was clean.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By 1998Zuki250
      Looking to see if anyone has any input on ATV Tires? 1998 Suzuki quadrunner LTF250
    • By Whiterabbit
      3500lb, synthetic rope lead and everything needed to install for........................................ $89 bucks!  I'm installing one on my '01 Bombardier Quest and it looks like a legit buy. If you have a RK nearby & you need a winch you might want to swing by before they disappear.
×
×
  • Create New...