Quantcast
Jump to content

Recommended Posts

Posted

Hey guys new to the site, it is really cool.

I have a 2003 honda four trax es 250 electic shift

It has been running great but now stalls when i give it gas. It will start right up, but even if i feather the gas it stalls??? I have played with the idle screw but no change any thoughts would be greatly appreciated.

Posted

My '05 Rancher was doing that and it was the carburetor. I ended up replacing it and have had no problem since. Might be able to clean it out instead of buying a new one.

Sent from The Dark Side

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Popular Now

  • Similar Forum Topics

    • By realpilot
      I am unable to find a wiring diagram for this UTV.  When I turn the switch to on, the contractor does not engage.  The Brake pressure switch and the parking brake switches work correctly. What else should I be looking for?  All of the diagrams I have found are for newer models and the wire color coding is different.
       
      Thanks
    • By Cj Winds
      I have a 2009 Honda Rancher TRX420FA with shifting problems.
      Usually it shifts ok when cold but after couple minutes it will stop shifting with no codes.
      The 1st shift clutch oil pressure when in first gear is 74psi. The 2nd shift clutch oil pressure when in second gear is 74psi.
      The 1st shift clutch oil pressure when in neutral is zero. The problem is when the tranny is in neutral the 2nd shift clutch pressure starts around 10-15psi and builds to 20psi. Is this normal?
    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By Mikey509
      Hey guys, so I've been messing with my quad, and between all the starts, the battery is dead. Is there a certain way to charge these? Can I just throw a trickle charger on it and call it a day? can i also jump it like a normal car with a battery pack or is that to much voltage 
    • By Mikey509
      Hey guys i recently got a old recon 250 up and going and the prev owners had the carb screws all messed up. i was wondering if anyone can give me the basic run downs on if i turn both screws all the way "tightened" how many turns out will the quad run okay so i can then dial it in. the prev owner had the screws messed up so bad it woudnt idle. i got it to idle but idles rough. its super lean any guidence is appreciated 
×
×
  • Create New...