Quantcast
Jump to content


1997 Yamaha Kodiak 400 4x4 - Smoking Bad

Hunter

By Hunter
in Yamaha ATV Forum

 Share

Recommended Posts

Hunter Rookie

Hunter

Posted
Posted

I have a 1997 Yamaha Kodiak 400 4x4 it has a bad smoking problem the smoke on start up is a blue color and after it runs a while the smoke turns kind of blueish gray could this be the rings, the valves or something else, please help with any advice, P.S. there is also a little oil blowing out of the exhaust please help thanks.:GEEK:

Link to comment
Share on other sites
oxidized_black Grand Master

oxidized_black

Posted
Posted (edited)

could be just rings, could be just valves and/or guides, or all. try a compression test to narrow it down. if you have good compression, it could be just the valves or guides ... not sure how many lbs compression you should have, probably 130 anyway ... more than likely it is valves if it's blowing out the exhaust ...

Edited by oxidized_black
Link to comment
Share on other sites
Hunter Rookie

Hunter

Posted
  • Author
Posted

ok Thanks for all the input I will do a compression test and go from there, it seems to have good compression when I pull on the pull start rope as it has a lot of resistance and is very hard to pull, but thank you for all the advice and I will do a compression test to make sure I will let you know what I find, Have a Great day.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • semicolon
      TRX350D fuel pump problem
      By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • HSTAR
      1997 Yamaha big bear 350 Shift shaft issue
      By HSTAR
      Hey I have a 1997 big bear 350 4x4
      I replaced the shifter shaft and the shift arm linkage and the rod when I installed them all I was unaware that you had to line the dot on the shifter shaft with the gap on the linkage arm gap put it all back  together and rode it I can't get it to shift in the right gears  I can move the shift cam by hand and goes in different gears but with the shifter shaft in it riding I can't put it in R or N 
      Anyone know how to line up the shifter shaft and the shift cam s
       
    • ResQ91
      1987 Yamaha Big Bear Electrical Troubleshoot
      By ResQ91
      Hi guys
      My 87 Bear 350 won't start and could use a hand.
      Turn key on and Oil light turns on and then slowly fades out. (I think this is key to this) No start, not even a tick.
      battery and connections good
      A Solenoid post jump turns it over
      Neutral Safety Switch wire attached and seems good
      It has not had a wire/switch on Rear Brake Pedal ever since I had it.
      Any thoughts on some other things to troubleshoot this??
    • NZrider
      Suzuki King Quad 700 problem
      By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • HoldenBoy
      Starter not staying engaged while cranking
      By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...