Quantcast
Jump to content


2002 Polaris Magnum 325


Deerslayer

Recommended Posts

My friend's 325 has a loose A Arm on both sides of the front and you could tell that there was a rubber or poly bushing that was virtually non-existent on both sides. I order the flat bushings that appeared to be the missing spacer but they were actually the metal bushings. Looking at the manual for my 500 sportsman it appears that there is a "long bushing" and wondering if anyone knows if that is the one with the rubber or poly end on it. Also any tricks to doing a quick change out instead of full disassembly of the front suspension? Thanks for the help!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By mga
      I have to replace all 4, how much is involved?  Will they slide out of the front yoke? Or, do the boots just slide over the wheel end?
       
    • By dvs1961
      Just bought a new hisun ,been shopping for a year or more for a sxs   best bang for the buck...Are there any lift kits out there for a 2022 Hisun 750 sector ? links thanks
       
    • By Params_sweden
      Hi!
      I got my KLF300 running again with your help a couple of months ago, at that time it was the ignition coil that had failed. It has been in use since then without issues until two weeks ago.
      When the new issue showed I was going at about 10km/h and it suddenly slowed to a halt. I started it again after that with choke and I drove it 400 meters and parked. Next time it was really hard to start, and since it was low on gas I thought that was the problem. It didn't get any better with a full tank, so I assumed it was the cold weather, and adjusted the pilot slightly.
      After that it I actually got it started again with full choke and some slight gas, I drove about 300 meters and then it slowed down to a halt again. After that, it hasn't started again.
      The compression is 165psi. The spark has good intensity, the ATV has functioned before with the same spark "intensity"/light. I *assume* that it has gas as well, there is definitely gas on the spark plug when I remove it
      I have checked the carburetor slightly, the float works, diaphragm looks ok, but I haven't disassembled it to really look for dust and such in all the small places.
      My theory right now is that it might've been some dust in the gas tank that went into the system, it's just a theory
      I'm thankful for all the help and pointers I can get, don't hesitate

      / Pär, Sweden

    • By neilmmr
      Hi I had an issue with a Polaris 325 ace . It was pressurising the water system. I’ve stripped the engine and had the head skimmed. Would anyone have torque settings and correct timing procedure/marks thanks 
    • By gohndd
      Hey guys, I have a 1999 king quad. The right front brake locks up when I squeeze the lever. I can loosen bleed screw, fluid will come out and it unlocks. I'm thinking maybe wheel cylinder. Any suggestions?
×
×
  • Create New...