Search the Community
Showing results for tags ' grease'.
-
Replacing one of the front lower boots on a '11 700 grizz and not sure where to source the part. This is my first service job on this bike or on an atv period. I'd like to get at least OEM, but if there's something better that's not too much more I'd probably go for that. What's the best place to source this part w/ the best price? So far I've found... YamahaPartsNation.com YahamaPartsPitStop.com BikeBandit.com RockyMountainATVmc.com And last, I've watched a couple youtube vids on doing the boot swap and seems fairly simply. To change out the lower boot you have to remove the whole axle (jerk it out), take the top boot off, dismantle the top side, then replace the bottom boot from the opposite side. But when they go to put the axle back in I haven't seen anyone mention regreasing the splines of the axle before reinserting? Surely this is just something they've left out. What type of grease should be used here? Any tips on doing this job much appreciated!
-
The (haynes) service manual says to use "hi temp brake grease" on the front brake drum (water) seals that go the large circumference of the backing plate to seal against the drum. Is this the same as hi temp wheel bearing grease. Did a google search and found no decent reference to hi them brake grease. What to use?
-
I am repairing my 100 for the grandkids, the rear axle pinion gear is chewed up, but luckily I found a used on from an old moto 4 80cc that is interchangeable...I only had to change out the axle hubs, and they are splined, so that was easy. I now need to fill the rear casing with grease, as I cleaned all the old grease out. What should I use for this? It is sealed when assembled, with no way to check it or fill it further. Any help is appreciated.