Search the Community
Showing results for tags 'low compression'.
Found 3 results
So few months ago I acquired a 01 Explorer 4x4 (think its a 350 but not sure) Anyway the owner said it started reving very high, shut the key off and still kept running until finally he shut off fuel and it finally died. During the run away he said the exhaust got red hot and has melted plastics to prove it. Said some thing flew out the tail pipe, I kinda figured it was the top of the piston. Anyway finally got around to looking at it (have a lot of other projects in the works) and checked the compression, Shows about 40 psi. Can hear air coming out the carb while rotating the motor over. Gonna pull it apart eventually, don't hear any noises or binding in the stroke, You think the piston came apart? any horror stories of these and is it worth my effort and money? Don't really have any money in it yet. Thoughts? Az
Ok, so I bought this scream of a deal the other day - a 94 King Quad 300 for $40.00. It's been sitting outside with no carburetor on it for about a year. Its rusty, missing some parts, wiring is all cut up and spliced etc. No seat, no racks but the plastic is all there minus the headlight housing. Anyway, who can pass up a $40.00 quad right? I get it home and looked at the sight glass for oil level, it's about 1/2 oil and 1/2 water. I drain it, refill it and turn the motor by hand (recoil starter is missing) and it turns over just fine. I worked on the wiring for about an hour and got it to turn over with the electric starter and got enough of it sorted out to get a spark. Did a quick compression test, 70 lbs. Wet test bumped it up to 90. Ok, so rings and cylinder washed out with water for a year, not too surprised. I thought 'what the hell' and sprayed some starting fluid in it and it ran for about 2 seconds - enough to show it's got life. Since then the compression has gotten worse, I can't get enough pressure to activate the carb diaphragm, therefore no fuel pump either. The compression is now around 60. Anyway, my question is....is it worth it to try to get this thing going? I tore the top end down today and the cam and one of the rockers is pretty worn. I figured a top end job would be about $100 or so, depending on the condition of the cylinder but I'll probably have to put a cam and rockers in it as well. Doing some research on ebay I figure I'll have to spend about $500-$700 to make the whole machine right again. Much less just to make it run and use as-is but I won't really like it until it's right. I don't mind doing the work, I actually enjoy it but I'm concerned about what all that water did to the rest of the internals, I can't really test it all out until I can make it run. I know it's a basket case but I'm not into it much at all, even if I do the top end and find something else wrong I'm still not out much. I'm leaning toward ordering the top end parts and going from there unless you can convince me otherwise - any way to check the rest of the internals without tearing it down? I plan on flushing the oil cooler before I do another oil change, I've drained it twice now and it gets milky almost immediately just turning the starter - I suspect the oil cooler is polluted badly. I'll get some pictures today if anyone want to see them. thanks!
I have not been able to start my 300ex that I just got off a guy. I was able to getting it running once, then never again. After a week of trying to make it run I got a compression tester and it is saying about 30 psi. Is this definitely the rings just worn out or can it be something elses? I can't even make it pop when I spray stater fluid in it.