Search the Community

Up until the other day, I could electric start in any gear, now it will only start in neutral. Thanks for any help:)

I have a Yamaha Timberwolf 250 2x4 that I purchased a while ago as a project. I fixed it up to where everything was working great in my opinion, however when I showed it to a potential buyer he complained about a vibration from the rear drive shaft. (Which I ridiculous seeing as he tried to wheelie it before that) Anyways I took the rear diff apart and found most of the seals and bearings where bad. So I bought a kit off of amazon only to find that it doesn’t have all of the bearings and seals. After finding that I decided to try to find a used good condition replacement but they’re all to expensive for me so is there a better alternative for me, or can someone point me in the right direction to get the rest of the parts?

At a loss... Runs/starts great when jumped across solenoid. Solenoid has been replaced. Battery has been tested and is good. Doesnt start with start button but starter will engage when machine is running if button is pushed. Machine also is not charging. Regulator has been replaced. Stator has been tested and passes all 3 phases voltage and open to ground all 3 phases. Lights work great with machine running and battery disconnected. Starter solenoid relay has been replaced. Any help or suggestion much appreciated. I do not have a wiring diagram or manual which i probably should try and get. Thanks

Hello folks, I have a yamaha timberwolf 250 motor I'm putting into a tri moto 200 frame and need some help with the wiring for it. The wiring harness I got with the motor has been damaged and missing a small section so my issue is that I have 3 white wires coming from the stator assembly which connect into another 3 white wires on the voltage regulator. My question is does it matter which of those white wires go connected together or are each of the white wires different and need to be connected to the appropriate wire on the voltage regulator. Any advice or help is appreciated. Thanks.

It will go into neutral, 1st, 2nd, and reverse but nothing after 2nd gear. The shifter moves freely going up completely nothing but when you shift down it works. I’m not sure if it’s tranny issue worth messing with or if I should just buy a new one. Overall besides that the thing runs like new.