Quantcast
Jump to content

Recommended Posts

Posted

Help! This hub has been soaking in liquid wrench for two days now. The hub puller in the picture has been on under tension with an impact wrench for 24 hours, removed and re-tightened at least twice in that time. I've tried smacking it from two sides simultaneously with ball peen hammers while under tension and also heating it until the liquid wrench began to smoke also while under tension and it's not budging. Anyone have any advice?

b9fa289db0dfeaca8445703355dbcae6.jpg

Sent from my SM-G920V using Tapatalk

  • 2 weeks later...
  • 1 month later...
Posted (edited)

Get the puller as tight as you dare, then chase the hub quickly with a torch. Heat will make it swell. Don't pu*** it, you need to get the hub as hot as possible as quickly as possible before the axle takes and expands. Like, cherry red. Not just burn oil. You need more then 300*F....

Sent from my One using Tapatalk

Edited by Cyberballz

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By That229Yamaha
      Hey guys, I’m new to the forum. What I got is a 2001 Yamaha Bear Tracker 250, got it as a project on trade and the problem I’m dealing with is a “no spark” problem and been trying to hunt down the cause for two weeks. I’ve replaced the stator, pick up coil, CDI, wiring harness, ignition, coil pack, spark plug, solenoid, battery, etc. and I’m still not getting any luck. Even tried bypassing the kill switch. I also noticed two things on this quad, another CDI under the back plastic by the voltage regulator, and a blue and green wire coming from the motor behind  the foot shift, tried to hook it up but it broke off and I’m thinking the broken wire would cause it to have no spark, if not then I need someone’s help on this and wanna see if I can get spark again. If anyone knows why I have this problem, the help would be greatly appreciated.
    • By Doublewidekings
      I am looking for what you would consider the best ATV winch for under $125.  Thanks in advance.
    • By Cobra_kai83
      The gas in the tank was bad so I drained it and put new fuel in. It still wouldn't run so I took the carb out and cleaned it. Re-installed the carb and now it will only start and run under full throttle. It also runs rough like this. The engine stops running once I back out to 1/4 throttle. What the heck is going on?
    • By JoeB
      Considering pulling the pin on an ARGO xplorer 570 xrt 2 up unit. Has anyone had any experience with these. They offer a pretty good sounding warranty but I don't know anyone who's got one to know if they're good about following through on their warranty promises
    • By Tjp5093
      I'm working on my 02 Honda forman 400 and I have the side case off. I'm trying to see a picture of how the clutch fork and clutch arm on the end of the shifter shaft line up and what direction to face the triangle bearing with the spring.TIA!!!
×
×
  • Create New...