Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

dboy910

1988 Big Bear 350 Reverse selecter

Recommended Posts

Ok new to group and new to quads. I picked up a 88 Big Bear for next to nothing but it has issues. The entire high low revers shifter has been removed. All I have is a bar attached to the linkage. I can shift into all three but I would like to replace or get suggestions. I have looked around but there is limited info or pictures on what I would need to buy or where it even mounts. Any pics of what where and how it works would be great. Or direct me to correct thread.

Thanks

Share this post


Link to post
Share on other sites


Try going to bike bandit .com and enter the quad u have. They will diagrams for every single system on the quad. They will also have part number and if you choose to pay that much for new parts u can order the part straight from them so you know u are getting the right thing. I normally like there to find the parts I need then buy the parts off eBay used.

Sent from my XT1585 using Tapatalk

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By JacobSlabach
      hey so never ran into this before but i recently got a 04 honda rubicon 500.  bought it from my doctor not running and the front brakes were locked up.   cleaned the carb and it fired right up and runs great.  these model atvs have drum brakes front and rear.  not a fan.  lost all brakes on this one when i hit some water and it got inside the rear drum case.  so i ordered new shoes for the rear end no biggie.  front is more complicated.  has hydraulic drum brakes not sure who thought that was a good idea but the pistons in the drums rusted and locked up from it sitting with moisture in the drums.
      so i had a choice to make- 1. buy new brake pistons ($120 for a set of 4) or 2. order super atv's disc brake conversion kit for $250.  i HATE drum brakes so i went with the conversion kit.  it said it was easy to install with no specialty tools.  so i order it and turns out i have to press the studs out of my hubs to get the disc on.
      anyone ever done this and if so how?
    • By JacobSlabach
      picked up this pos bike for $80 not running.  took it home, cleaned the carb and bypassed the fuse-  ran great (other than the rev limiter- those things are so stupid)  Then one day out of the blue it starts flooding on cold startup and wont idle cold, but idles to fast warm.  (too fast being about half throttle speed heh).  I tried a new carb ($10) and new sp.  new carb wouldnt make it run except on choke and then it was gushing white smoke.  I had better things to do with my time so I parked it in a shed and used it for a work bench for a while...  this last weekend, I wanted to take it along with the sportman to a mens retreat to let the younger boys have some fun on it--  took about 30mins to pull all the crap I had accumulated on it and then rolled it down to my workshop, put the old carb back on after adjusting the needle clip up two notches (leaner) and threw it back on the bike.  Will turn over, but no fire.  I didnt have time to check sp that day but just wanted some incite on what could be wrong with this quad (if it even qualifies as being called that)
    • By Steve Stahlschmidt
      Will not start with out a shot of ether then only runs until it's burnt! Replaced fuel pump, carb, fuel filter, fuel shut off, new plug! I'm lost now! Could it have a bad coil? prior to this it would start and run fine!
    • By Christy Miller
      Need a wire diagram for 
      99 big bear 350 4x4 can anyone help I have no spark my roommate drove it ended up losing the battery and it grounded out a.wire in the middle of harness was burned to BEAR any suggestions ty
    • By Bryson Bailey
      Hey I have a Kawasaki buyou I put a new carburetor on it and a brand new spark plug coil and still firing up could you know what my problem is anyone please
  • Similar Tagged Content

    • By Guythis448
      Looking for help on wiring up stock wiring harness specifically for a '88 Honda TRX 300 
      If anyone could drop a link or send me a PM it would be much appreciated 
    • By wHarmon
      Our 1988 Yamaha Terra Pro is finally seeing the finish line of becoming our new bush hogging tractor! I've had the terra pro for almost 2 years... we had great intentions, but after removing the fenders, fuel tank, and the carb, we let it sit up. Shame on us! However, the terra pro is cranking today. We cleaned the carb, figured out what goes where and where did that screw go! She smokes like there's no tomorrow, but that's okay! The only issue right now is getting all these lines hooked back up to the carb right! There is 5 lines to hook up to this thing!! And in our moment of drinking and removing parts, we cant remember how they go back on. I've found several diagrams online, but none showing the overall schematics of all the lines! If anyone has a service manual, or any way of helping us figure out what goes where I would really appreciate it!! I can attach pictures later if it'll help!
    • By alexcross324
      Hi all, I try to find this manual in the threads but you have a lot of stock here
      Cannot find this particular manual.
      I found it for YFM200 but not sure if they are the same.
      Thanks if you could help me with that.
      Im new here so if I did something wrong, please tell me.
    • By alexcross324
      Hi all, my second post here
      I got an old Yamaha 88 moto 4 and I have a problem with my overflow hose from the carb.
      When I put the gas switch to ON a big amount of gas is leaking from the overflow...so I start using my quad with the gas switch to RESERVE wich is also leaking but less than in ON position.
      I dont ride a lot..but in a week I empty my gas tank.
      Strange.
      I never clean my carb because Im new to quad world and dont have the service manual...so I need you point of view.
      Thanks guys!
    • By mallen14
      Looking for anybody who can point me towards a free service manual for 1998 Big Bear 350. I found the sticky thread but all the links, from 2012, no longer work. If anybody has one please let me know. Thanks
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...