1987 Yamaha YFM225 4 wheeler

[Paul Leatherman]

Hey all,

I am in search of a rear collar/hub part #2HT-25383-00-00 for my sons 4-wheeler. Of course it is very hard to find.

Does anyone have any idea where i might find or would a cross over from a different model work?

Thanks,
Paul

[davefrombc]

Try  contacting www.bikebandit.com and see if they  can  cross reference a hub from Honda or  another manufacturer  that  uses a similar axle hub.

[Paul Leatherman]

Awesome thanks for the information!

[jford]

I, too, am looking for this elusive part.  The site listed above.. no longer exists.

I'm trying to find something that will work, a 25mm shaft with 24 teeth, but thus far, no luck. Any kind of cross-over, or something that comes close would be great..  I really like the old yfm225, used it out on the ranch to check fences. I hate to think that it's scrap for just a hub..  Any hints or help would be appreciated.

Thanks in advance!  John

Austin, TX

[Gwbarm]

I would try ebay,  I use Ebay mostly for unobtanium parts.

[jford]

I appreciate the response.  I've been checking ebay, so far without results (discontinued item).  There is one offering out there for the complete axle, rear end assembly, but.,  Spent time on amazon, going through the possibilities, but most of the "might fit" offerings don't have all of the measurements needed to pull the trigger.  Heck, I even discovered that there are listings out there for atv junk yards, and have a few requests out to those, but again, thus far, no cigar. I'm thinking I might try to drill through and add a shear pin type arrangement, or worst case, just weld the thing onto the axle, but since it's on the brake fitting side, figure as soon as I did that,.. I mean, it is getting on in years, but it's a lot more fuel-efficient than the cvt atvs, and quieter as well.

I'll keep looking, and hoping.  Again, thanks for the response

[Gwbarm]

I like the older at ones myself I will keep looking also let you know if I find anything you might try the pin for a temporary fix until you find one

[jford]

Went to daily searches on ebay, and finally found one (almost didn't believe it!).  I'm back checking fences, but she still has a driveline "clunking" in higher gears under load.  I'd hoped it was the axle slipping in the old stripped hub, but will wait and see what gives out next.

 

[Gwbarm]

Good you found one if you are persistent they will generally show up. Great place to get discontinued parts