Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Sign in to follow this  
ATVNetwork

Building Your ATV Mechanical Skill Set With 5 Easy Tips

Recommended Posts



Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Similar Topics

    • By mjm4jc
      Hello eeveryone,
      Just picked up an 86 Suzuki LT185 for my daughter, and she's complaining that it bounces so bad over bumps that it nearly throws her off the quad. I have the tire pressures some where around 3 psi. I really can't go any lower than that. I noticed that there isn't anything in the aftermarket world for shocks and springs for this quad. I am wondering what others are doing to soften up the ride. Also wondering if there's a way to fabricate a rear shock, since there isn't one.  I appreciate your feedback.
      Thanks!
    • By gareth leifheit
      Ive got a Big Bear 350 4x4 that has been sitting for a couple years. It was put away running but now the pull start wont move and the starter wont turn it either. Any ideas what I can lube up or bang around to loosen it up? Thanks
    • By Dominic Tiberio
      I was given a Zhejiang Yongkang 500W electric ATV that has had all of the wiring and controls stripped  from it. I plan on installing a new speed controller, but I am having a hard time figuring out how to handle the braking. The 500W electric motor is connected to the rear axle by a chain/gear and it has mechanical disc brakes. I can't figure out how to handle braking without risking damage to the chain/gear and since it is stripped I don't have much to go on. I'm assuming that the brake was originally set to cut power to the motor when engaged, but it seems like it would still put a lot of stress on the chain/gear at any speed. I've never rebuilt an ATV or electric ATV, but I have a lot of mechanical and electronics experience. Any help or insight is appreciated!
    • By Ben Cramp
      I am hoping one of you knowledgable people can answer this for me. I have a yfm200 moto 4 engine I want to put in an off road go kart. I would like to mount a sproket where the drive exits the case before the u joint so that I can get rid of drive shaft and make engine bay compact. To do this I would mount engine 90° to axle but would also need to tilt it forward 15° to account for the angle the drive exists rear of casing. Would that be ok? Would oil pump etc still work. Any advice greatly recieved.

    • By Brenden
      Hi, I just bought a used 1990 warrior and the rear is sagging low like it has a lowering kit but I’m not sure, does anyone know what it could be?



  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...