Quantcast
Jump to content


oil in your ATV coolant tank?


Recommended Posts

If the leak is in a oil pressure galley the oil pressure would be higher than the coolant pressure so you would have oil in coolant but not the other way around. However in this case it would be in the radiator as well not just the overflow. (Radiator contents not specified in question). Also is oil disappearing over time with no smoke.

Link to comment
Share on other sites

  • 2 weeks later...

I would suspect the oil seal behind the H20 pump as well. Could be head gasket too though. I'm not sure if there is pressurized oil behind the H2O pump or not but I do know that there is oil pressure though the head gasket and if it ever got too hot it could damage the head gasket and the oil would leak into the coolant system. Some coolant would leak into the oil after shutdown and would collect at the top of the engine. Pull the rocker box cover and see if there's chocolatey goo in there. If there is you've got a faulty head gasket.

Link to comment
Share on other sites

  • 2 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Werewolf
      Oil is getting in the air box from crankcase vent tube, I put the two hoses that go to the air box together then something started to smoke on the front of the engine. There is a filter? In the line I blew that out.
    • By JohnnyB
      Greetings, 
      Have a 88 LT80 that been sitting for a couple years. Bought a new piston, cylinder and head. Installed these, rolled it over and it quickly locks up.  Took carb apart. It was full of what appears to be 2 cycle oil. Cleaned it, but keeps locking up and 2 cycle oil continues to seap from exhaust port.  When i installed new cylinder, I noticed crankcase was full of oil.  I'm now wondering if that oil is what's getting sucked up into cylinder.  Should there be no oil in crankcase?  If that the case, how is crank and rod lubricated?  Sorry, never worked on a 2 stroke. Thanks!
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
    • By Slitzer
      How often do you change oil in front/rear diffrentials and gearbox?
×
×
  • Create New...