Quantcast
Jump to content

Recommended Posts

Posted

I have a '01 500 quad master , i rebuilt the carb last spring an it ran great til 2 weeks ago now when i start it up runs great for about 2 minutes then it stalls sputters an backfires an when its in gear it wont move , but at idle it runs fine , i took the carb off took it apart an everything looked ok , blew it with the air nozzle put it back together an it didn't help it, I'm going to order another rebuild kit, any feedback or ideas would be greatly appreciated , thank you

Posted

Have you checked the fuel flow from the tank ? Sometimes the petcock has a screen or a blockage that does not allow the fuel to flow freely.  Also the air/fuel screw, was it put back in properly? I’ve seen people put the washer in before the o ring etc. So be sure it’s back in the right way. 

Second is the bowl and fill pin working and set correctly. It might be set to low and closes off fuel to the carburetor prematurely. 

Lastly I always recommend sending in a small piece of wire through the ports on the carb. Sometimes air just isn’t enough to clear out a tiny hole like that and the final adjustment. Air fuel adjustment set point? What did you set it at and have you tried to adjust it while the bikes running?   

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
    • By Mister907
      Hi guys, I have a 2004 big bear 400. Last winter while plowing the driveway, I heard a loud pop from the left side of the engine. It continued to run as I looked for leaky fluid, but then died shortly after backing it up and won’t start now. The oil light comes on when I try to start it, no noise or anything else. 
      No blown fuses that I can find.
    • By Brent Wright
      What's a good size to start a 10 year old on?
    • By HeWasRidinDirty
      The one I need to replace has a 2 wire plug coming out of it. Searching eBay I see tons of them with only 1 wire . WTH???

×
×
  • Create New...