Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
So just as a general FYI, it might be good to check replacement parts before installing. If possible, check clearances with a micrometer before going through the trouble of assembly. I say this as I bought a new driveshaft yoke for a Kodiak because the ujoint dropped a cap and got the yoke in a bind...blowing the yoke and middle drive gear to shreds. So I replaced the middle drive gear and bought a new yoke and ujoint kit from Caltric. Caltric is usually pretty solid replacement parts. The new yoke however was a good 4mm too narrow for inside lock ujoint caps. Disappointing since it came as a kit from Caltric.
Ended up taking an angle grinder to the new yoke and thinning material off to get it to the needed 41.25mm opening size. Sucks having to disassemble everything again and start over but my fault for trusting replacement parts. Nearly 40 years of turning wrenches and I made a rookie mistake.
By colin james
View File 2017-2019 sportsman 450/570 with eps factory service manual
This is the factory service manual for the 2017-2019 factory service manual for the sportsman 450/570 with electronic power steering
Submitter colin james Submitted 09/06/2018 Category Polaris ATV
Anyone know where I can get a free download? I had one a month or so ago on my 'puter but one day it flipped out and I lost it. I gotta put the top end of this 450 together (hopefully today) and I need some info. I've searched and searched this morning, but, I can't find one. Thanks!
I recently read an article about restoring or at least improving the looks of faded and discolored plastic body parts. In the article it suggested using a 50/50 mixture of boiled linseed oil and paint thinner. You mix it up and apply it with a brush or rag to rub it in and remove the oxidation. I curious to find out if anyone has had experience with doing this and what was their short/long term results of doing so. I would hate to try it and find out that a few weeks/months down the road my plastic body parts self destruct.
Similar Tagged Content
these are what i have in my collection ... always looking for more
Linhai 250 - 360 Service Manual
Linhai 260 - 300 Parts Manual
Linhai 260 - 300 Service Manual
Linhai 300 Parts Manual
Linhai 260 Service Manual
Linhai Bighorn CUV Service Manual
Recently Browsing 0 members
No registered users viewing this page.