Quantcast
Jump to content

Recommended Posts

  • Ajmboy changed the title to 2013 Bennche Bighorn 400 Charging light
  • 1 month later...
Posted

Hi, did you still need help with your Bighorn 400?  If you're replaced the charging coil / stator.  I would say your remaining culprit for sure is your regulator-rectifier, they go rather often, gone through 2 myself.  Quick check, put your meter on the battery, note the voltage (12.5V~), then start the machine.  If the voltage stays the same or drops slightly, or even rises a little bit but stays below 13v, I'd strongly suspect the regulator is blown - no charging.  You can also quickly check your new stator - I think 3 wires.  Disconnect the 3 wires, does each one show maybe 20+ volts AC to ground on a meter while idling?  Hope this helps, let me know if I can further assist - Cheers!~  Bellarmine

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Suzukiquad
      Hi, I have been around everything with a motor since I was little, and finally purchased more to get my husband, and kids involved. I have 4 quads I will be searching around for information on. I have two 2002 Suzuki LT80K quads, a 1997 Yamaha Timberwolf 250, and a 1996 Kawasaki Bayou 220. I have had different ones throughout the years, and plan on buying another Yamaha Banshee. I plan on trying to learn more about all of them, so I can customize some of them. I know nothing about them besides how to race them, my dad always took care of the rest, but figured it was time for me to learn. 
    • By Travis_Smith
      I have a 2002 Kawasaki Prairie KVF 400 and im trying to figure out the actual float height... i have read 17mm +- 2mm, seen 13mm and 23mm... what is happening is it will start right up, rev a little and all is fine, when it warms and you put a load on it bogs down and sputters. no i don't have a manual
    • By KSIM
      View File CFMOTO C-Force 400 service manual
      C-Force 400
      Submitter KSIM Submitted 03/19/2025 Category CFMOTO ATV  
    • By Kawasakibayounospark
      any one know much about how this system works. Replaced voltage regulator cid box coil pickup coil have power to cid box none out to coil any thoughts. This is cid box number three 
    • By TravisM
      2001 bayou 220 KLF220A
      Need some help putting a new ignition switch on this thing. I'm not finding homes for all the wires. I can hook up the white wire and brown wire, But the switch has a B/W and Solid Yellow wire i can't find a home for, and there aren't any more wires in the vicinity from the harness that match this, except one red wire with a double female end crimped on, and a few B/Y grounds. None of the wiring diagrams i've founder or have been given match.
      I'm also wondering if i have the wrong switch? some switches appear to have 4 wires and other just 2, the Brown wire and a White wire.
      I'm at a loss here. Thanks.
       
×
×
  • Create New...