Quantcast
Jump to content

Recommended Posts

Posted

2005 King Quad 700

 

Took off the front plastic and pressure washed it.  unfortunately while doing this I lost the metal insert of a rubber grommet.  There are 2 rubber grommets with inserts on the front, Left and Right.  The screw that goes through here holds the front cargo rack on.  Any ideas where I can find a replacement?  id take the metal insert or a whole new rubber grommet with insert if I can find it.  Pics are front and back of both grommets, one with the insert, one without the insert.

 

IMG_1498.thumb.jpg.5045b6954184ea10aef0d3088200817d.jpgIMG_1497.thumb.jpg.8c12b76817ae5a1577dbd4ea03ac25cb.jpgIMG_1496.thumb.jpg.254e4a0b3318e19c593b8b7d53681610.jpgIMG_1494.thumb.jpg.0ae93d74e83bf2a19d4d6e5fafb6ae3f.jpg

Posted

A dealer would be one place, but that could be expensive.

I've used Partszilla to find the manufacture part number by looking at their exploded parts diagrams, you'll just have to start picking componets to see if any show the detail your looking for.  Once you find the part number you can then search on other sites (google) to find it cheaper.

 

Here is a start:

https://www.partzilla.com/catalog/suzuki/atv/2005/kingquad-lt-a700x

 

Good luck!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By Johnnynv
      I recently bought a 2006 KFX  700 that had been sitting for 10+ years, started to replace the fuel system and the fuel pump has a connector that does not fit the same as original.  The plug has opposite slot as original.  There are two plugs on fuel pump bracket, some tiny sensor and fuel pump.  The new fuel pump plugs in the same place as tiny sensor, where as the old fuel pump plugged into opposite position.  I took old connector off bad fuel pump and repined it to new one, but now am questioning if this was the right thing to do.  I did pay attention to wire placement but just feel like there should be a direct replacement.  From the pictures on partzilla website, I cannot find a different option.  Has anyone run into this issue?
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
×
×
  • Create New...