Quantcast
Jump to content

2000 Arctic Cat 500 3402-195 shim 20mm

dpal65

By dpal65
in Arctic Cat ATV Forum

 Share

Recommended Posts

dpal65 Newbie

dpal65

Posted
Posted

Can anyone point me in a direction to find the specs on a shim for my 2000 Arctic Cat 500 part is unavailable and can't seem to find any info. such as thickness. The part number is arctic cat "3402-195" shim 20mm. Secondary transmission spacer/shim. I bought it used and it wasn't there when I took it apart to change starter gear.

  • Admin changed the title to 2000 Arctic Cat 500 3402-195 shim 20mm
Mech Grand Master

Mech

Posted
Posted

I'd suspect the 195 is a measurement, either 1.95 mm or .195 of an inch.. I'd check the end-float and if it was near either of those measurements I'd accept it as the thickness..

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Forum Topics

    • noticon75
      Anyone ride in Kansas
      By noticon75
      Anyone ride at in the north east Kansas area? Tuttle Creek, Milford lake areas, Topeka?
    • tepin
      Багги Arctic Cat 700 инжектор 2008г пропала искра
      By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • Maxg_57
      Anyone there?
      By Maxg_57
      Is anyone still active on this club
    • Shorty51
      2006 Arctic Cat Utility transmission drive shaft replacement.
      By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • toe420
      Anyone from BC?
      By toe420
      Anyone here from BC? Where do you ride? 

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...