Polaris solid axle locknut tool?

[Dan Kroes]

Does anyone know if there is a tool for torquing the bearing nut and jam nut on Polaris solid rear axles? Seems like it must exist if factory says 150 ft lbs. What would it be called?

[Mech]

Crowsfoot spanner ?

[Dan Kroes]

Thanks Mech, I found some things called torque wrench adapters but can't find them big enough. I see the crowfoot and flare nut adapters. Not sure if the flare nut type would handle the torque or not...

[Mech]

I doubt the flare nut type would be made for that torque.. 

To tell the truth though, I doubt it needs to be torqued precisely. If you have a torque wrench that goes to 150, or close to it, put it's drive in the vice and get a feel for what various torques feel like, like start at eighty and then try one-hundred then one-twenty or whatever your wrench will go to, then just make an estimate and do the inner nut up reasonably tight and then crank the outer/lock nut up to as close as you can calculate it should be with a plumbers wrench/pipe wrench or big crescent.