X-Tream Clean New Product Announcement
-
Popular Now
-
-
Similar Forum Topics
-
By WeeBee
I'm looking at buying a New "CarryOn" 5'x8' Trailer with the Ramp Gate and Mesh Floor from my local Tractor Supply store ! Anyone have any experience with this Brand of trailer to share ?? Thanks!
-
By Maddman200
Can anyone recommend a good quailty bottm end rebuild kit for a 09 grizzly 700. I need to replace crankshaft and bearing and do not want junk quality?
-
By jhamrick75
If anyone is having issues with the Mikuni VM24SS carb, I thought I would post what issues I had and how I resolved them.
Acquired a 93 Bayou 220 that had sat for over 4 years.
The carb was extremely corroded and pitted and full of leftover fuel.
Cleaned carb and bowl and was able to get the engine to start.
Within 30 seconds exhaust would heat up and start to glow red hot.
Removed carb and recleaned everything, including a second overnight soak.
Needless to say, after removing the carb for the 5th time and my frustration to the limit I
realized that my attention had been to the carb body and not to the bowl.
There is a small brass rod on the bottom of the carb that goes down into the float bowl but is seperated from the main section. I had cleaned that area very well....I had thought.
***The corrosion had sealed off the channel that runs from the main bowl section to the small tube section on the side of the float bowl. No amount of carb cleaner was going to get it to budge. So i took a small nail and started to scrape away the corrosion and was eventually able to dislodge enought of the corrosion that carb cleaner would flow through that channel. ***
I thoroughly cleaned each side of the channel in the float bowl and reinstalled the carb and now the issue of it running lean is gone.
On a second note the fuel mixture screw was a nightmare to remove as the threads had been corroded and wouldnt let the screw come out. I used a little cutting oil and worked the mixture screw in and out until I was able to push past the corroded threads and completely remove the needle. After a couple passes with a tap to clean the threads it is like new again.
Hope this helps if you are having a lean running machine.
-
By motox88
Anyone have bad experience with these clutch kits? Looking to get one for an 80s quad that I have.
-
By Clydaho
I just bought a 2022 Sector 550, it has 22 miles on it. Driving down a flat gravel road for 2 miles, and it starts blubbering and missing. Then it catches and runs fine for a bit, then starts blubbering again. Then I went up the neighbors steep driveway and it blubbered and then ran Ok, then blubbered again, then ran ok, then blubbered again, I wasn't sure I'd make it.
Got home, let it cool down and then recreated the trip. Two miles of level gravel road, then it started blubbering again. Didn't try the neighbors driveway. Didn't want to have to walk home.
It seems as if when it reaches a certain temp it starts acting up. It isn't getting hot, gauge reads good.
Any ideas? Years ago a Polaris snowmobile was acting up like this and the temperature sensor wire was loose. That is not the case here.
It seems like an "Ignition Interuptis" scenario, but not sure where to look.
Fuel? New machine with new gas? That shouldn't be it.
Probably going to take it back to the dealer tomorrow, but am hoping to get any ideas from you Hisun guys.
Any ideas???
Thanks for the help.
Clydaho
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.