-
Similar Forum Topics
-
By lindzjo
Does anyone have a service manual for Qlink 700 atv.I cant find anything on one.Please help
-
By QuadDad22
Picked up a 86’ LT 185 for $10 in trade value(my items only cost me $10)
recoil only , I pull the recoil and it won’t move , so I took it off , I can spin the crank there one full turn left then it locks up , and one full turn back to the right and it locks up
pulled the plug , the piston is moving up n down , both valves are moving(pulled the caps)
pulled the clutch off , oil pump gear , and it still locks up after one turn
any ideas or where to go from here would be greatly appreciated
im a 2 stroke guy so this all is new to me
thank you in advance y’all
-
By Makj44
Hello I have a 1999 Honda 300 4w/drive and I just replaced the Oem carburetor with a aftermarket carburetor after installing the carb on the bike it started great and idled like new one but when I shifted into first gear and tried to move forward it died, I shifted back In neutral and the wheeler started easy again I let it set there to see if maybe it needed to warm up but when I shifted into first and tried accelerating it died again, I am not a use to working on it and would appreciate any advise thanks
-
By Robin442
Hello all! New to the site, I came here seeking answers as I've decided to help my cousin get his once good running buyou 220 going again.
I've owned an 82 kawasaki kz1100 and have done lots of work to it over 20 years of ownership.
Looks like the wire diagram colors are same or similar to my bikes wiring, a definite plus
Cousin was riding through fairly high weeds and brush after it's rained, when it just died. It would turn over but no fire.
This to me sounds like perhaps a CDI issue or a fried coil, idk that why I'm asking you gurus LOL
-
-
By Domshook
I recently got a 2003 yamaha kodiak 450 with a bad starter clutch. And when i go to replace it i noticw there is no woodruff key and the brass bushing was split. Now i have to basically press on my idler gear. Im pretty sure this is wrong and i need help i have tried 2 different companys. Please help. There is no play in the crankshaft and no obivous marks or wear signs.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.