-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
-
Similar Topics
-
By alexwv1863
Hey everyone, I have an issue with my dad's 03 Yamaha Kodiak 400. It had been running great but he left it sitting for a short amount of time. When he started it, it ran fine for a little bit but all of a sudden it quit taking gas. I thought it may have been the carb because it him not running it. The carb ended up being pretty clean. He put it back on and after taking it off and cleaning again, I'm beginning to wonder what it could be. It'll start and idle just fine, but when you go to give it throttle, it'll die out. It sounds like it's not getting air right but idk where to look or what else it could be. I'm stumped and need to figure this out before I go crazy. Anyone have any ideas???
-
By FalloutBoy
I can't find a diagram for my Can-Am, all the diagrams have different color coded wires and are missing the necessary parts to fully re-wire my Can-Am. Any help would be appreciated
-
By glencam
Hi everyone new to this forum so thanks for taking the time to read my questions. I have an older 88 Big Bear 350 and it wont go into Hi range ....well I think its Hi it wont go into it may not go into low range it will go into reverse when i shift the shifter it moves all the way back (i removed the pin and manually shifted it ) forward is reverse middle is low and all the way back is hi but when in hi position its like its in N no forward movement of the machine in any gear. I did get it to work once but then shifted to reverse to get it out of garage and the problem returned.
Where is the Hi/Lo gears actually situated? by removing the right side cover to expose the clutch will I gain access to the shifter?
The "Middle Gear" housing on the other side (left) does it take gear oil ?
thank you
-
By BlueBowtie
Is it possible to put a motor from a big bear 350 into a timberwolf? Reason I ask is that I have a timberwolf with a bit of a rod knock, and I have big bear with a bad rear end and axle with a good motor. So, is it possible?
-
By oxidized_black
Yamaha ATV manuals are located in the downloads section here at QUADCRAZY.
Please visit the downloads section at https://www.quadcrazy.com/files/
Get 15% at emanualsonline.com with coupon code EMOAFF
Get 20% at emanualsonline.com with coupon code BLAZE and $50 purchase
Clymer ATV Manual - Yamaha Raptor 700R
-
-
Similar Tagged Content
-
- 0 replies
- 1,778 views
-
- 0 comments
- 2,184 views
-
- 2 comments
- 3,350 views
-
- 21 replies
- 13,678 views
-
- 7 replies
- 4,122 views
-
-
Gallery Images
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.