-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
-
Similar Topics
-
By alexwv1863
Hey everyone, I have an issue with my dad's 03 Yamaha Kodiak 400. It had been running great but he left it sitting for a short amount of time. When he started it, it ran fine for a little bit but all of a sudden it quit taking gas. I thought it may have been the carb because it him not running it. The carb ended up being pretty clean. He put it back on and after taking it off and cleaning again, I'm beginning to wonder what it could be. It'll start and idle just fine, but when you go to give it throttle, it'll die out. It sounds like it's not getting air right but idk where to look or what else it could be. I'm stumped and need to figure this out before I go crazy. Anyone have any ideas???
-
By oxidized_black
Yamaha ATV manuals are located in the downloads section here at QUADCRAZY.
Please visit the downloads section at https://www.quadcrazy.com/files/
Get 15% at emanualsonline.com with coupon code EMOAFF
Get 20% at emanualsonline.com with coupon code BLAZE and $50 purchase
Clymer ATV Manual - Yamaha Raptor 700R
-
By Tucker17
Just replace the crank trying to figure out exactly how to set up the timing the dots on the crankshaft gear and on the balancer gear are they supposed to match as it rotates
-
By Thom592
The 400Big Bear I'm working on, had a couple issues. Starter is spinning backwards.. What would cause this?
The brushes are in place and I could find no burnt marks inside..
Any Insights would be greatly appreciated.
-
By Gwbarm
I got my no spark issue sorted out, got it running on the old aftermarket carb, but it didn't want to take throttle even after cleaned it, didnt really want to waste time on it, so I order a new one which is on its way, so not much to post here, but I wanted to start a new thread. I am stating to clean up the plastics thought I might as well do that while they are off, they were a mess tree sap, bird dropping, mold and what ever. Washed them good and got all off so I could see the oxidation , decided to wetsand with 600 grit waterproof sandpaper, and used Armour All instead of water. I figured it could put some of the moisture back in that was lost from sun exposure.
Working fairly well I will keep going finer on the grit and see if it will polish
-
-
Similar Tagged Content
-
- 7 replies
- 4,122 views
-
- 0 replies
- 2,995 views
-
- 1 reply
- 4,301 views
-
- 5 replies
- 6,761 views
-
- 2 replies
- 2,425 views
-
-
Gallery Images
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.