mywifeknowseverythin

WTB: Complete 300EX front End

1 post in this topic



Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  •  Like what you are reading? Please help us by sharing this content.
  • Similar Content

    • By dglover1226
      I have a 01 raptor and recently had to bore it out to a 686 because it sucked in a bunch of sand. Now I have no torque or power in the first third of the throttle. I am hoping that someone else knows what is going on with it
    • By Vinsonary
      Ok everyone, I've been rebuilding the top end of my vinson 500 and here is my problem. After replacing all the gaskets and getting my timing set I was all set to place the head on when I realized I had left one of the two small sleeves that position the cylinder head on the base. To go back and put it in would require another complete tear down. This is one of those round cylindrical tubes that the jug sits on. All bolts are in along with Indian head gasket shellac on both sides of the gasket, my question is what might it hurt if I don't put it back in? Honestly I can't see where it will matter and setting the timing on this machine is a real bitch. Anyone have any thoughts on this?
      Sent from my iPhone using Tapatalk
    • By shanes1031
      Im loking at buying this atv, owner said when he put in gear and drove it that it made a grinding noise so they parked it, said he has the rear end off but hasnt taken it apart yet, sounds like bearings any other ideas? Very nice shape can get for 600
    • By Jc4360
      I've taken the rocker cover off the motor I see that the timing chain goes all the way down to the crank how can I take the top end up with the chain well I need special tools and what with the torques specs be. I appreciate any input I can get