Quantcast
Jump to content

Recommended Posts

Posted

I got a 1986 suzuki 230lts it has been sputtering and spiting when you add a a little throttle so i took apart the crab to look for crap, i found not a speck of dirt. BUT i found that the pilot screw was messing a few parts, the washer and the o-ring. would that cause it to sputter when a little throttle is applied, it almost feels like the breaks are dragging when you give it a little throttle. thanks for any imput!

Posted

I would replace the missing parts and make sure all of the passages and jets are clear. I would also drain out any old gas and start with fresh fuel if you haven't already. I would also check for air leaks, make sure your air filter is clean, and make sure you have good spark. Get a repair manual, you will most likely need it.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Forum Topics

    • By Elk
      2002 Polaris Magnum 325
      How to replace throttle assembly spring?
    • By jay41198
      I am missing a cdi box for my 1988 Suzuki quadrunner LT 4WD is there a rplacement box that i can wire into this bike to get it back running beings that the cdi box is no longer made 
    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By kevinohio
      Does anyone have a copie of the owners/operators manual.the basic book that comes with the atv.i need the smaller one.i have the great big repair manual one.
    • By buriedpast
      As the title says, I've got a crankcase full of fuel / oil to deal with and figure I'll just start from the top and move through the system.  Going to start with a rebuild of the petcock and then the carb if the problem isn't fixed with the petcock rebuild.  I figure I'll go with a Moose kit unless others with experience recommend another brand (All Balls, etc.)
      Any suggestions?  Thanks in advance.
×
×
  • Create New...