Quantcast
Jump to content


2000 Suzuki Quadmaster 500 oil leak question.


hydaftl

Recommended Posts

Oil seal on your water pump. That hole is there so you can tell if you have lost the seal on your water pump impeller shaft. The weep hole is sealed off from the water side, and from the oil side where the pump is driven from. Most of the time you will see the water side fail first and water will come out of that hole. But sometimes the oil seal fails and you see oil come out of the weep hole. Behind the impeller, you will see a mechanical seal first, then an oil seal. I would replcace them both. Inspect everything else for excessive wear as well.

Edited by DirtDemon
Link to comment
Share on other sites

  • 13 years later...

I’ve got a 99 LTF 500 with a slow oil leak. Have you found leaks anywhere else besides on your machine? I thought maybe the oil plug was leaking. Changed the plug and washer to no avail. Still leaking oil from underneath somewhere. Is a slow leak for sure. I’ll have to inspect the water pump in mine also. Thanks for the info. Regards 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By JohnnyB
      Greetings, 
      Have a 88 LT80 that been sitting for a couple years. Bought a new piston, cylinder and head. Installed these, rolled it over and it quickly locks up.  Took carb apart. It was full of what appears to be 2 cycle oil. Cleaned it, but keeps locking up and 2 cycle oil continues to seap from exhaust port.  When i installed new cylinder, I noticed crankcase was full of oil.  I'm now wondering if that oil is what's getting sucked up into cylinder.  Should there be no oil in crankcase?  If that the case, how is crank and rod lubricated?  Sorry, never worked on a 2 stroke. Thanks!
    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
×
×
  • Create New...