Quantcast
Jump to content

2004 Suzuki Ozark 250 - Idle Problem

foreman

By foreman
in Suzuki ATV Forum

 Share

Recommended Posts

foreman Newbie

foreman

Posted
Posted

I HAVE A 2004 OZARK 250. I pulled it out after winter and now it is not running right. It starts up fine idles fine and runs fine up to half throttle. As soon as u hit half throttle it just starts dieing(spitting and sputtering). I put some seafoam in the tank and it kinda cleared it up a little(when in nuetral) but as soon as u put it in gear and hit half throttle it runs bad again. any info helpfull.

cheriah Collaborator

cheriah

Posted
Posted (edited)

take the carb off and clean the whole thing...and use fresh gas....check the tank screen for obstructions and check your fuel filter also..all of them can get gunky from sitting...1/4 --3/4 throttle is the jet needle and needle jet, the main jet holder may be gunky....good luck:wink:

Edited by cheriah

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • BillR94
      1998 Polaris Magnum 425 starts but dies right away.
      By BillR94
      I picked up this ATV that had no spark. The previous owner said he was driving it and it died and would not start. He discovered it had no spark. He replaced the CDI and the coil with no luck. He got tired of it and I bought it. I replaced the stater and now it has strong spark. Now, it starts for a second or two then dies. It will not stay running. I have checked the timing and it is spot on. The valves are adjusted correctly. I see no warn issues with the cam. I put the original CDI and coil back on it. Same problem exists. Compression is at 65 psi (has decompression mechanism),
      I took off the muffler in case the issue was clogged pipes. No change. I replaced the spark plug. No change. The carb was an aftermarket so I put a Niche carb on with no change. I bypassed the fuel pump and that did nothing to solve the problem. 
      I don't know if this is a carb issue or an ignition issue. I am looking around locally for an OEM carb to try out but not sure that will fix the problem. 
      Can anyone help me solve this problem. I am running out of ideas. 
      Thank you for your time
      Bill
       
    • joezee13
      honda2004 trx 350 wont turn over after turning off
      By joezee13
      After turning off engine in neutral  starter wont engage If I rock unit back and forth it engages Getting progressive worse.
    • middlebrookgt
      2006 Eiger LT-F400F will not go into gear after generator cocer replacement
      By middlebrookgt
      Hi All.  I introduced myself some weeks ago with my 2006 LT-F400F that needed a list of repairs including replacing the cracked generator cover.  It is back together as of last night and cranks up, idles and revs high pretty well.  Needs some fine tuning and stop backfiring at stop.
      The big issue is it will not go into gear.  I reassembled the insides with help from y’all’s posts.  The transfer selector moves from H-L-R, and the foot shifter moves thru the gears and finds neutral easily enough.  Before I tear it back open, the  transfer selector on top does not move as far as the repair manual says.  The diagram shows the shaft moving something like 40 degrees between L and H and 50+ degrees between L and R but it doesn’t move that far even though it finds the indent areas and moves well.  
      Could this be the problem.  I aligned all the dots on the shifter gears inside and it appeared to not be binding anywhere.  I do hear the gears touching when I shift like they are trying to engage, but zero movement from the ARV
      It was somewhat difficult to tell whether all the parts are installed on each shaft.
      Are there better/bigger photos somewhere that would allow me to be confident I included all the washers and bushings, etc?  If I had any doubt on parts that were laying inside after the cover broke then I purchased replacements from online stores.
      TIA for any input or feedback!!  Pics are from when I first took the generator cover off.


    • 97kingquad
      Suzuki king quad 300 idles great but Boggs when you apply throttle
      By 97kingquad
      Okay so I bought this 1997 sazuki king quad from a guy and he had it for a few years. 
      He had it registered and on the trails last year but he said it bogged and backfired when he would try to drive it. so it sat for a year. 
      I bought it for 800 bucks and got it running that night and it ran great for a few days 
      But I parked it the other night and went to start it again and it was really hard to fire up and when I did it was bogging and idling high then low again.
      So I took the carb out and cleaned it (ended up doing it twice because it was still doing the same thing) 
      Now today I have it running slightly better, but it is still like 20% 
      I have been looking it up and trying to figure it out but I can't find the issue, has anyone else had this problem? I'll attach a video of it running and giving some throttle 
    • Ejwill
      2007 Hond fore 500 4x4 es trouble after top end rebuild
      By Ejwill
      I rebuilt the top end on my 2007 Honda Trx500fe. It ran fine right after the rebuilt. But now when I try to crank it it blows Bach through the carburetor. I held my hand over the opening for the intake air and it blew gas back on my hand. Can figure out what happened all of a sudden. It was cranking and was able to ride it running through all the gears. Now can get it to crank just blowing gas back to the air filter. Need help again. Starting to think I should have walked away from this one.

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...