-
Similar Forum Topics
-
By 86ccord
Starting this build thread to keep up with everything on my build and hope to motivate someone!
I picked up this 2008 Yamaha Big Bear 250 2 weeks ago. A guy that I hunt with parked it at the hunt club for a year or so before I asked him if he wanted to sell. He said " fill my feeder and throw some batteries in my cameras, and you can have it". Sounds like a deal to me!
I have attached some pictures of how it sat under a tarp in the woods and when I got it home and cleaned up a little.
-
By Need-help-with-quads
So my moto 4 is smoking white smoke and when I go to first gear and get about half throttle there’s no power and it sounds like it’s bogging
-
By Kaz
Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
-
By heath
i just bought a yamaha moto 4, i have sprayed 'start ya barstard' into the carb and on the spark plug and it doesnt even fire! although when i have the spark plug on the outside of the motor it shows spark, the engine also leaks oil from the starter,
-
By Wam12905
Hey all!
I recently acquired an 02 big bear 400 this past summer, carb on it was shot to sh** (pics attached) so my father recommended I just buy a new one off amazon. I purchased the first one that came up as compatible and once it came in, I bolted it in and it fired right up with no noticeable issues. Once I got to the trails with it I realized that on any un-level ground, there's little power output. I checked with 3 different local shops and they all refused to work on tuning up off brand carbs because of how terrible they are. One shop had a motorcycle in with an aftermarket carb and the mechanic said that that would be me if I brought my big bear in. Whoever owned the motorcycle and needed their aftermarket carb tuned up had racked up the bill to nearly $1500. Needless to say he made it clearly obvious that putting any amount of money into an aftermarket carb is not worth it. Now that I've learned all of this, I'm wishing I didn't toss the old carb for a $30 amazon one. In light of this minor f-up does anybody have any recommendations for high quality carbs for my vehicle? I've also attached pictures of the old carb and its condition for your curiosity, although its current condition is likely 6 feet under in a landfill somewhere.
https://www.ebay.com/itm/283488113569?_skw=Big+Bear+400+Carburetor+Oem&epid=10042848409&itmmeta=01JCDWCTMJX5GBC407RF2PPVDD&hash=item42013553a1:g:INUAAOSwn8llquIL&itmprp=enc%3AAQAJAAABAHoV3kP08IDx%2BKZ9MfhVJKkIMhqd%2Fye0vA0YMR5DUzMoCLl0F9GPNRfuAJKaylVqqyVrZCBJVvXQaPrlosjt%2FZnIHyIRPuGiIbxC9o%2B02UqGA4YqXDyyH4bVebnTPz8P5Elg76CvLdu3KyZgwpgpSeYJK2IOWtlo9vtTld7RVjqPwSv1VF26v6kyXGesAB%2BA%2BCHsj3OnqNrHMyKCBuDMSSvUWvOfq%2BKsZKqyHR7yduef%2BHBlXvfiyRJPThHr7Ge9n%2BHBbuxRCb4oF7%2Fp8oZsvajHy9YDitFRfNJeeAssYbgXuhAc7AVvUZZ2YxKW9GzDdxltLMap8orKJtr%2BIk0SRGQ%3D|tkp%3ABFBMsqqzvONk
I found this one on EBAY that advertises as a genuine OEM part for a fraction of the $650 that they're normally worth. Any help would be greatly appreciated, thanks!
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now