Quantcast
Jump to content

Recommended Posts

Posted

I have a stock 2001 TRX 350 rancher 2 wheel drive. Been going rockcrawling on it and have had backfiring on downhills. Pulled carb and went from stock 130 main jet to a 142, replaced slow jet from 42 to a 45, reset the jet needle from stock 3rd slot to 4th slot and have the A/F screw at 3 turns out. Have Uni filter in stock air box. Bike is now hitting rev limiter in all gears, and will pull front wheels off ground. Can go from full throttle to no throttle and not noticing any popping now. My question for anyone, has anyone done similar changes? Any suggestions for other improvements? Don't really want to change exhaust, don't really need any more power and don't want anymore noise, but, would consider a quieter pipe. Also, I see that the thermosensor on this bike is set around 308 degrees, I have noticed that I can ride the heck out of the bike and I don't hear the fan come on. I have tested the fan and just replaced the thermo switch because I thought it wasn't working. Anyone had any issues with this?

Thanks, Anthony

Oh, ride in NW Arkansas, elevations between 1200 and 2000 feet.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Popular Now

  • Similar Forum Topics

    • By Cj Winds
      I have a 2009 Honda Rancher TRX420FA with shifting problems.
      Usually it shifts ok when cold but after couple minutes it will stop shifting with no codes.
      The 1st shift clutch oil pressure when in first gear is 74psi. The 2nd shift clutch oil pressure when in second gear is 74psi.
      The 1st shift clutch oil pressure when in neutral is zero. The problem is when the tranny is in neutral the 2nd shift clutch pressure starts around 10-15psi and builds to 20psi. Is this normal?
    • By 88classic
      I have (2) sets of brand new plastics available for Honda Rancher 420 2014-2023. These are genuine genuine OEM Honda plastics. One set is white and the other set is green. The boxes these are in are too big to ship.(Unless you want to pay for it. If so, lookup your own shipping rates from 17325 and box size is 58"x35"x18").  $400
       

       

    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • By rjsummer
      I have a 2015 Outlander L 500 max. 
      any way to change the start up message in the cluster WITHOUT taking it to the dealer and paying $100???
    • By P_syko
      Which is more reliable? Shaft or chain drive? 
×
×
  • Create New...