-
Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
-
Similar Tagged Content
-
By ssbsh21
I bought 2 older yamaha's, one is an 86 and the other is an 87, they are both the exact same but one has a different engine code and I was told one was 80cc and one was 85cc. Problem is that I can not find any atv made back then that would have came with an 85cc engine. I believe they are little badgers and they only came with 80cc I think. Engine codes on them are 800cm3 and 850cm3, not sure if that will help anybody but if you can explain this nonsense to me I would appreciate it because I need to buy a few parts for them.
-
-
Similar Topics
-
By Abbeypalm
While cruising, my 2011 750 king quad suddenly shut down. As it happened, red lights on the display flashed. Any ideas? My head lights suddenly stopped working about a week ago, if that helps. I have no power at all. Thanks
-
By technofarmer
Hey there, i have recently put a new drive belt on my 11 Polaris Sportsman 500 H.O. It has 44 miles since putting the new belt on and should be nearly broken in as i hear it takes 50 miles to do so? Anyhow it has had a little trouble with slipping since i put the new one on a few months ago. Now whenver i go down a hill the belt seems to be getting caught in one clutch if not both and then it has to run a high rpm just to go a low speed. Today it did that again going down hill, i stopped, put it in neutral and when going back up the hill i had to turn it off, put it in neutral, let it roll back down the hill a little, then restart it, low range and it was slipping but thankfully i was able to make it up the hill.
So what might the problem be? Is this a need for another new belt? New clutches and belt? Or just get something else? BTW the brand new belt i put on it, is a factory one, an exact replacement for the original.
-
By oxidized_black
View File 2006 - 2011 Honda TRX 250EX Service Manual
5851e0ba82762_2006-2011HondaTRX250exServiceManual.pdf
Submitter oxidized_black Submitted 12/14/2016 Category Honda ATV
-
By Spartacus Stroppel
So I have a 2001 Kawasaki prairie 300 I could not find tough country snow plow... it's a older plow too boot... so I made the plow mount and updated the plow with some skids.
Mount plate is 1/4 steel plate and so are the pin points
The skids are off a moose plow. I got some plumbing black pipe for holders to weld to the blade and braced it with pieces left over from the plow mount 1/4 steel...
1/4 plate cost $45
Skids cost $24
U bolts and other hardware where $20
I got the blade free
-
By Ajmboy
View File 2009 Polaris Ranger 700 4X4 Crew / 6X6 Service Manual
2009 Polaris Ranger 700 4X4 Crew / 6X6 Service Manual
Submitter Ajmboy Submitted 10/31/2020 Category Polaris UTV
-
-
-
Recently Browsing 0 members
No registered users viewing this page.
