Quantcast
Jump to content


1998 Kawasaki 300 - Carb Trouble!! Maybe??


Recommended Posts

I have a 1998 Kawasaki 300 2x4. new carb,spark plug. I got it to start by pull start at first.got it to idle but when I give it gas it revs high and will not go back down. After pulstarting it 20 something times, Now electric start is starting the engine. Can anyone Help me??

Edited by sking3111
Link to comment
Share on other sites

Sounds like you have a problem with the throttle cable to the carb . If that cable sticks or is even remotely re routed wrong then that would make the cable too taunt and therefore take away some of its length. Try turning the handle bar too and fro to see if anything happens. If it does change anything then I will say try rerouting the cable.

Also just to be on the safe side check the new carburetors main needle that's the long one that goes down thru the center of the carburetor to make sure it is clipped in. The clip should be in the center notch it will appear to be a little loose when you hold it and move it side to side but it shouldn't be able to move up or down.

Also, check the rubber boot between the carburetor and the engine for possible cracks or broken flange. That would cause it to race also because now its running way too lean. Get that fixed immediately if it is. Too little gas and too much air will damage your engine.

hope this helps, good luck.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By bob2007
      Hy there great to be able to communicate with people having knowledge I have a continuous problem with a leaking carburetor and I just saw a small rubber hose detached from the bottom of the carburetor and i cannot find were it should be attached and how the two side should be affixed to the carburetor any suggestions as i cannot find a description plan on it thank you Bob
    • By newguy024
      Just got into ATV riding just last week, never had much money so i couldnt afford to buy anthing, so now at the age of 34 i just bought a 1987 suzuki quadrunner 300 for 500$ took it out a few times and what a rush of excitement to go through that first mudhole haha!
    • By justent_88
      Hello, im looking for some input on this situation i have. My 94 Mojave has no spark, and i have no idea what it is. Ive replaced/tested the magneto, the pickup coil, cdi, the ignition coil. Even the key and Killswitch. I haven't tested the harness its self, but i have tried another harness and still nothing. The only thing i can think of is the fly wheel itself. I have found a lot of metal shavings in the fly wheel and have cleaned it the best I could. But nothing happened afterwards. I am truly stumped here and hoping some of yous could shed some knowledge/ideas that could help get this thing to fire. 
    • By ATVNetwork
      he fifth round of the 2024 ATV Motocross National Championship Series, an AMA National Championship, took place at High Point Raceway View the full article
    • By cavry
      Wiring shows White and Brown to solenoid blades. Then a black wire from starter circuit relay to solenoid. I am confused,  where is that black wire supposed to connect?
      Thanks for any help
      Cavry
×
×
  • Create New...