Quantcast
Jump to content

Recommended Posts

Posted (edited)

I have a 1998 Kawasaki 300 2x4. new carb,spark plug. I got it to start by pull start at first.got it to idle but when I give it gas it revs high and will not go back down. After pulstarting it 20 something times, Now electric start is starting the engine. Can anyone Help me??

Edited by sking3111
Posted

Sounds like you have a problem with the throttle cable to the carb . If that cable sticks or is even remotely re routed wrong then that would make the cable too taunt and therefore take away some of its length. Try turning the handle bar too and fro to see if anything happens. If it does change anything then I will say try rerouting the cable.

Also just to be on the safe side check the new carburetors main needle that's the long one that goes down thru the center of the carburetor to make sure it is clipped in. The clip should be in the center notch it will appear to be a little loose when you hold it and move it side to side but it shouldn't be able to move up or down.

Also, check the rubber boot between the carburetor and the engine for possible cracks or broken flange. That would cause it to race also because now its running way too lean. Get that fixed immediately if it is. Too little gas and too much air will damage your engine.

hope this helps, good luck.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
    • By Mister907
      Hi guys, I have a 2004 big bear 400. Last winter while plowing the driveway, I heard a loud pop from the left side of the engine. It continued to run as I looked for leaky fluid, but then died shortly after backing it up and won’t start now. The oil light comes on when I try to start it, no noise or anything else. 
      No blown fuses that I can find.
    • By Jdeaton011989
      Hi all. I have a timberwolf 250 2nd that will not start.. I thought it was out of time bc the guy I got it from said it just quit on him. The tensioner had a nut welded to it and it was like2 teeth off. I installed new tensioner and chain and it still will not start. It has fire and it will not hit off brake cleaner. It has compression. Haven't put a gauge but I'm sure it will crank and run with what it has. I double checked my work and it's still in time. Spot on. Both valves move. I'm about to put a feeler gauge on them and I'll cone back but other than that any ideas?
    • By Brent Wright
      What's a good size to start a 10 year old on?
×
×
  • Create New...