Quantcast
Jump to content

Recommended Posts

Posted

So I have a 1997 Yamaha wolverine 350 4x4 and am experiencing a clunking noise at low idle and it only happens at random. It seems like its coming from the lower end. Engine seems to hesitate when it happens. And ideas!? Thank you

Posted

I checked the starter clutch and it seems to be working properly. It's coming from inside the case towards the front on the right hand side if you were to be sitting on it. Looks like the only way I may find out is by opening it up. I do plan on re-building the top end this winter.

Posted (edited)

Hmm, It strikes me as odd that it only happens randomly. Id be eyeballing thing that change their mechanical position in a different manner after each start-up. Could the flywheel be loose? Maybe the stator plate screws loosened up? Exhaust pipe cracked or loose causing a random leak? Id be checking external stuff before jumping in & cracking the case upen. In my experience a bad crank bearing or something like that usually doesnt go away then come back. Good luck with it though.

Edited by Mudflap64
added content.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By wanrep
      View File 2019-2024 Yamaha YFZ 50 service manual
       2019-2024 Yamaha YFZ 50 service manual
      Submitter wanrep Submitted 05/04/2025 Category Yamaha ATV  
    • By wanrep
      View File 2017-2018 Yamaha YFZ 50 service manual
      2017-2018 Yamaha YFZ 50 service manual
      YFZ05YYXH
      YF05RH
      Submitter wanrep Submitted 05/04/2025 Category Yamaha ATV  
    • By Atomusthenes
      I would appreciate being pointing in the correct direction for a wiring diagram and or schematics of the 88 Honda FourTrax 300 4x4 if anybody has any knowledge of how to test the ignition system stator and CDI I don't know if the voltage regulator probably and also the FCU I put a new ignition in it it is a cheap aftermarket one doesn't have the correct plugs but has the correct wiring scheme I get power  the neutral light comes on and the oil light stays on it turns over but I have no spark
    • By Tim Keiper
      1st problem, Does anyone know where I can find a stock carb for my Timberwolf, I have tried two different aftermarket carbs and they both suck. The machine runs great until it gets good and warm, then it keeps stalling unless I feather the throttle. it will even stall while I'm trying to go from 1st to reverse or vise versa. I took it to a buddy of mine who is a bike mechanic for years, and he told me try to find a factory carb. When I look online from dealers it says "NOT AVAILABLE" anyone have any suggestions ?
       
      2nd, The small tab on the rear axle for towing is to short for even pulling my small yard trailer, I can't even turn a little bit and hit hits. I tried making an extension which worked great as far as length, but it bends the tab and then the extension drags the ground. I have an idea of what to do to fix it, but wanted to see if anyone else has had this problem and see how you solved it.
    • By BuckBilly
      I like to ride in wooded and grassy areas. It takes my mind off the everyday routines and helps me deal with my father's cancer. Also gives me a reason to get involved with forums like this one.
×
×
  • Create New...