-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
MotoFinder - The App to help you Braaap!
-
Similar Topics
-
By Yammy
Can you ride your quad on the road or cross a road if your quad is licensed and registered and you have functional signal lights and running lights?
Let me know, I'm new to this.
Thanks!
-
By remnar
New member here,
I have searched here and other places and have not found an answer to my problem. As the title says I have a 2014 420 Rancher that recently started having an issue were the revs before the clutch engages.
I have checked the oil level (per the service manual) and replace the Valvoline ATV 10w40(less than 5 hours) with 10W30 GN4 for good measure. I have used the "pin" method to pull a DTC. I shows a 8-1 which is a TPS error. This makes some sense, as if the computer doesn't read throttle position correctly, it could have this symptom. I have checked the source voltage, and tested the TPS off the quad with a Fluke and a power supply at 5v. It is smooth and does not seem to be a bad sensor. I am confused by the DTC, because the PS light blinks the code, not the check engine light. However, there are no PS codes of that value. This condition appeared after a couple days of driving in the cold (~32°) and driving though some water/bogs.
A couple questions. First has anyone seen this issue, and do you have any suggestions? I have followed the troubleshoot right up to the point of replacing the ECU, which I don't seem to have one on the shelf :)
Second, anyone used a OBDII reader with an a 4pin adapter to pull codes? If so, what system do you use?
Beyond the rev issue, the quad runs and starts perfectly and when it decides, the clutch grabs tight (no slipping)
-
By Werewolf
When I turn on key back light on the display works. The display shows shifter positions, temp and engine icon. But the main display is blank.
It will not start fuel pump not working, but that info would come from controll Modular?
Thanks for any ideas
-
By Oger69420
Just like the title says how do I find out what I have here I was told that it is a 1985 200 That is all I know and I need to Start looking for parts
-
-
-
Similar Tagged Content
-
- 4 replies
- 2,303 views
-
- 10 replies
- 4,509 views
-
- 22 replies
- 4,922 views
-
-
-
Gallery Images
-
1 -
3
-
4
-
7
-
6By BlueBowtie,
-
1
-
4By trxridr,
-
0
-
5
-
5
-
3
-
1
-
4By crazt4stroke,
-
1
-
2
-
0
-
0
-
3
-
4By mannyortiz7,
-
1By Llanier5,
-
-
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.