A Little Wheelie/Reverse Wheelie action.
-
Similar Forum Topics
-
By geezer99
I have an Axis 500 made by Hisun. I uses a solid rear gearbox with no differential action.
I would like to convert this to a true differential with locking ability. I've searched all over trying to find a source with no luck.
Has anyone done this before, or know of a source?
Thanks, Tom
-
By p5200
I'm assuming, it's alright to test the engine after adjusting valves without the rear axle installed? Can someone please verify this? I'm waiting on axle parts and wanting to get that done while waiting. Thanks! 🙂
-
By rockfresh15
Hey all, I'm a 2-stroke quad/dirt bike guy, new to utility atvs. Just picked up a pretty clean looking 2005 Kodiak 450 4x4 with about 1,000 hours on it for my dad.
The first thing I noticed when we got home was oil leaking from a seal on the rear axle. Pictured below. I've been staring at this frigan Partzilla diagram for days and can't figure out what part this is. What is it and what likely needs replacing/fixing?
Also wouldn't mind any recommendations on the next things to check. The owner said nothing's been replaced on it but oil since it's been in service. Def needs new rear tires.
Thanks all!
-
By SCmasterTech
I think I have a bad axle as only on wheel drives. I'll be taking it apart soon and was wondering if it usually goes bad at the hub or differential end?
-
-
By preppypyro
Hey guys and gals,
I recently bought a 1994 yamaha big bear 350 with... surprise surprise.. rear diff problems.
I have taken the rear diff all apart and the problem is the pinion bearings are both screwed. (Hope Im using the correct terms) Anyways there is a collar that has 4 "divets" in it that ya can beat on with a punch and it should turn. Well Ive beat on that collar and it is not turning. I have lubed, soaked, heated, cooled, you name it, and that collar will NOT budge.
So as a last ditch effort before I take a die grinder and grind that collar outta there, I thought I would throw a post in here, and maybe someone has some trick or advice they can add that maybe I havent thought of.
Now the axle, taking it out needed a beating, and I ended up screwing up the threads that hold the hub on, and eventually broke them right off. My plan is to drill about an inch hole in the end of the axle, thread it, thread a grade 8 bolt in there, loctite it in, then throw a bead of weld around the bolt. Im thinking for the little light duty puttering around I do with this quad, that this idea should be enough to repair the axle so the hub stays on, rather then fork out big bucks for a used or new one.
Thoughts on both repairs would be great!
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.