Quantcast
Jump to content


99’ Yamaha bear tracker 250cc engine problems


Recommended Posts

I have a1999 Yamaha bear tracker 250cc one day I started it with choke on and it idled for a min then clicked some and shut right off. I was using the pull start to start cause something wrong with starter but it won’t pull any at all now like it’s locked up  can someone tell me what the problem might be

Edited by Allen Junior
Link to comment
Share on other sites

Welcome to Quadcrazy. From your description it sounds like you heard a noise and then it shut off?  Is the bike in neutral ? It’s possable that the engine is seized up.  I would take the spark plug out and try to pull start it to see if the engine turns over.  Then drain the oil if there is any oil in the engine and see if any metal pieces are present.  It’s also possable that something else is locking up the engine causing it not to spin like a blown clutch bearing, maybe something came apart in the stator coil area or transmission. 

Link to comment
Share on other sites

  • 2 months later...

Yes I took out the spark plug and still won’t turn over I took apart the pull string housing assembly and was looking to see if something might have came apart in there but nothing      I can  turn back and forth about a quarter turn each way the part thats used by the pull string to start the engine but no more then that I also sprayed blaster down in motor where spark plug was just to see if maybe it would free up after sitting but didn’t work.    HELP PLEASE 

Link to comment
Share on other sites

Welcome back Allen. It honestly sounds like the engine has seized. I would take the head off exposing the piston and cylinder to see if there is any damage inside the cylinder walls. And maybe go further into this by taking the cylinder off completely. 

But prior to any of that make sure your not missing something else like the starter bearing or in the stator coil area   

Did you drain the oil? 

I have the same bike and it’s reliable and tough. But if there was no or low oil well that’s that! 

Hopfully you will find out and keep us posted. I’ve been a little busy since I opened up my own company but will try to check in from time to time. 

Goos luck. 

  • Like 1
Link to comment
Share on other sites

  • 10 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Brantley11
      Hey everybody,
       
      My proficiency is with Hondas and Yamahas make me see RED!
       
      This bike is my brother in law's, it has 1199 miles on it and went from running great to dead with no start. Every once and a while it will start and sputter for 2 seconds. It is extremely sporadic when it fires but never runs for longer than 3 seconds. 
       
      Here is where we sit:
      Brand New Fully Charged battery
      Carb was cleaned with air hose and carb cleaner then into the ultrasonic cleaner with Aircraft aluminum cleaner
      New Shindy Carb kit (made in Japan version)
      Cleaned out petcock and gas tank
      New 93 Non Ethanol Gas
      New Spark Plug
       
      It gets a spark through the spark test light every time
      Bluish white spark
      When holding the spark plug 1/4" - 3/8" away from head it will jump and spark to the head
      Good Compression
       
      Here are the readings:
       
      Pickup Coil 519 Ohms (range 459-561)
      Charging Coil 266 Ohms (range 270-330)
      Lighting Coil 0.700 (range 0.702-0.858)
      Spark plug Cap 10.58 Ohms (10kohms
      Ignition Coil Primary Coil 0.5 ohms (range 0.18-0.28 ohms)
      Ignition Coil Secondary Coil 8.20 kOhms (range 6.32-9.48 kOhms)
       
      Would y'all think stator and pick up coil, rectifier or CDI are the culprit?
       
    • By oxidized_black
      Yamaha ATV manuals are located in the downloads section here at QUADCRAZY.
      Please visit the downloads section at https://www.quadcrazy.com/files/
      Get 15% at emanualsonline.com with coupon code EMOAFF
      Get 20% at emanualsonline.com with coupon code BLAZE and $50 purchase
      Clymer ATV Manual - Yamaha Raptor 700R
       
    • By mga
      I just saw a video on TikTok where some guy took the rear end off an ATV and bolted on a roto tiller in place of rear wheels. I wish i saved that video to post here....good thing it was 4 wheel drive...lol but, it seemed to work.
      I'm not sure how he made it bolt on to the drive....
    • By Need-help-with-quads
      So I have an 89 Yamaha moto 4 250cc and when I ride it, itll get hot after like 10-15 mins and then will just die and turn off.
      It's has new carb rebuild, new air filter, new battery, new spark plug so I don't think it's a crack in the spark plug
      Can anyone help me?
    • By 86ccord
      Starting this build thread to keep up with everything on my build and hope to motivate someone!
       
      I picked up this 2008 Yamaha Big Bear 250 2 weeks ago. A guy that I hunt with parked it at the hunt club for a year or so before I asked him if he wanted to sell. He said " fill my feeder and throw some batteries in my cameras, and you can have it". Sounds like a deal to me! 
      I have attached some pictures of how it sat under a tarp in the woods and when I got it home and cleaned up a little. 
       
       



×
×
  • Create New...