Quantcast
Jump to content


Steering bearing

Lildaisygrl18
 Share

Recommended Posts

Lildaisygrl18 Collaborator

Lildaisygrl18

Posted
Posted

So the saga with the quad continues, for those who dont know I have a 1997 yamaha warrior that is a project quad. Me and my man are takin it apart and redoin stuff. The steering bearing retainer is locked on and we cant get the old bearing out, we have again tried everything from lubing , heat, cranking on it, to breakin a socket wrench tryin to get this thing off. Normally these nuts are supposed to be easy, any one have ne other suggestions on what to try???:aargh:

Link to comment
Share on other sites
ZacUSNYR Apprentice

ZacUSNYR

Posted
Posted

Not sure how it is on other quads, on Yamahas, the bearing drops in and then you thread a retaining nut into the shaft, the shaft is threaded. It is real low torque and comes out with a 29mm Allen wrench. Then the bearing will pull right out of the top.

The issue is the retaining nut has snapped a 1/2" Ratchet which had a 4' breaker bar on it. This sucker is in there. Heating it to red hot then muscling it may just bend the bracket and not break it free.

Link to comment
Share on other sites
Lildaisygrl18 Collaborator

Lildaisygrl18

Posted
  • Author
Posted
Not sure how it is on other quads, on Yamahas, the bearing drops in and then you thread a retaining nut into the shaft, the shaft is threaded. It is real low torque and comes out with a 29mm Allen wrench. Then the bearing will pull right out of the top.

The issue is the retaining nut has snapped a 1/2" Ratchet which had a 4' breaker bar on it. This sucker is in there. Heating it to red hot then muscling it may just bend the bracket and not break it free.

ha yeah what my honey said :yes:

Link to comment
Share on other sites
ZacUSNYR Apprentice

ZacUSNYR

Posted
Posted

won't be able to snap pics till later. I just brought it to a garage that the company I work for owns and I put 600lbs worth of impact power on it. Didn't budge. Went both ways.

They didn't have the time to put the torch to it. My little propane torch doesn't heat it enough I think.

Link to comment
Share on other sites
Lildaisygrl18 Collaborator

Lildaisygrl18

Posted
  • Author
Posted

We actually bought some gaskette remover stuff today. We heard on another forum that its worth a try to get that bolt out. That stuff takes rust off like you woudnt believe. We are soaking it in pb blaster tonight and then the gaskette stuff tomorrow night and we will try to pull it again after soaking it. My honey broke a breaker bar tonight thathe just bought tryin to get the damn thing off. :aargh::aargh::aargh::aargh::aargh::aargh::aargh:

Link to comment
Share on other sites
  • 9 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • Brantley11
      2000 Yamaha Grizzly 600 No start but with good spark
      By Brantley11
      Hey everybody,
       
      My proficiency is with Hondas and Yamahas make me see RED!
       
      This bike is my brother in law's, it has 1199 miles on it and went from running great to dead with no start. Every once and a while it will start and sputter for 2 seconds. It is extremely sporadic when it fires but never runs for longer than 3 seconds. 
       
      Here is where we sit:
      Brand New Fully Charged battery
      Carb was cleaned with air hose and carb cleaner then into the ultrasonic cleaner with Aircraft aluminum cleaner
      New Shindy Carb kit (made in Japan version)
      Cleaned out petcock and gas tank
      New 93 Non Ethanol Gas
      New Spark Plug
       
      It gets a spark through the spark test light every time
      Bluish white spark
      When holding the spark plug 1/4" - 3/8" away from head it will jump and spark to the head
      Good Compression
       
      Here are the readings:
       
      Pickup Coil 519 Ohms (range 459-561)
      Charging Coil 266 Ohms (range 270-330)
      Lighting Coil 0.700 (range 0.702-0.858)
      Spark plug Cap 10.58 Ohms (10kohms
      Ignition Coil Primary Coil 0.5 ohms (range 0.18-0.28 ohms)
      Ignition Coil Secondary Coil 8.20 kOhms (range 6.32-9.48 kOhms)
       
      Would y'all think stator and pick up coil, rectifier or CDI are the culprit?
       
    • BuckBilly
      The Official Good morning thread!
      By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
    • mga
      good stuff or snake oil?
      By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
    • mkibbe
      2014 Suzuki King Quad 750 irs Power Steering
      By mkibbe
      My 2014 750 king quad stalls sometimes when I touch or turn the handlebars,the problem has gotten worse,my machine has 475 miles and is only trail ridden,I have a new factory battery and i have 14.2 volts when the quad is running and 13.3 on the battery when not running,also using a multimeter there is no change in volts when turning the bars until it does stall,If I pull the 40 amp power steering fuse it will not stall.......I've been told its the ECU,Hate to buy one if thats not the problem,but its kinda leaning towards that,,,,,need some opinions.

    • Gwbarm
      Looking to buy a new SUV
      By Gwbarm
      I have been exploring all the options available, so many, its hard to choose. I have kind of narrowed it down to the Honda Pilot, Subaru Outback, and Kind of looking at the Outlander, although its a little small,  the new one is nice looking. Just wondering if anyone has any recommendations or gripes with any of these rides. I have driven Jeeps for the past 25  years and they have been great, but their price point has gotten to high. Expieriences good or bad would be helpful. Thanks!

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...