Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
Well I finally decided on the trailer to fit my needs , i decided on the “ Yutrax “ trailer, watched a few good reveiws on it , reasonable price , I ordered it online through my local tractor supply.
Hauling brush, and general on the property use , its for offroad only ,looks like a great trailer for chores on property
By Frank Angerano
So I decided to pick up a small trailer if I could get one for the right price. I found this one for a few hundred bucks on Craig’s list. It is a galvanized trailer which is exactly what I was looking for. The wood was shot and needed some minor repairs which I could care less about as long as the chassis was good.
I striped it down and put a new deck on. I had some vinyl realtree graphics that I had laying around so I added them to the fenders which I think worked out well. Very happy with this little guy.
I'm having the iron workers at my jobmake me up a few lightweight side rails that will have a 22 degree bend in them to accommodate the tires that slightly hang over the edge and will incorporate some tie down points as well.
Below is a quote from a response to similar question from yesterday:
"Easiest thing to check is trash in the main jet. if it idles fine, then the idle circuit and low speed jet is clear. if it bogs off idle that's when it's transitioning to the main jet."
I will go ahead and open up the carb and check the main jet, but please respond to this post as if the main jet is squeaky clean.
Below is my post:
Only starts and runs on Full chock.
Does not matter what position I have my "mixture" screw. Tried it at zero, 1 turn, 2 turn, up to five turns. Spent a few hours confirming that the position of the mixture screw does not resolve issue.
Runs great at idle and if I slowly engage throttle, it will rev up as expected. But, quick rev up or when I am trying to drive it, it spits and sputters and looses power.
I also use a propane bottle and did not find any obvious leaks, and the vacuum port is hooked to fuel peacock and I also made sure to simply block the port with my finger to see if that would resolve the issue.
New Carb (after market), New Coil, Fresh Gas. No leaks at manifold boot, hot battery. Good gas flow. Runs too good to be a valve issue, or cylinder, great compression.
I can move the choke out a tiny bit, and it will still run, but will still bog down when I try to power it up.
I also have a 250 trail boss Polaris that I require to run at full choke, but it has power at all throttle potions.
I suspect it is running rich as the choke is on, but will not run with it off.
Any details would be appreciated.
Someone rolled the ATV away from my apartment and I haven’t seen it since. It had a blue subframe. SS rims and a mossy oak camo vinyl wrap. No telling what it’s like now.
The post Honda TRX450R 2005 Stolen appeared first on STOLEN 911.
View the full article
Recently Browsing 0 members
No registered users viewing this page.