Quantcast
Jump to content

Recommended Posts

Posted

I have a 2008 loncin desert storm that wont stay running.

When it ran it ran rough and backfired a lot.

Now it will only start with throttle and there's a lot of unburned fuel (white smoke), there's also compression comming out the airbox. Is it the carburetor that is broken?

Posted

4  things  could  cause that problem.   Timing slipped   so  the  intake  valve   is  still partially open  when  cylinder fires ,  Intake  valve  is sticking slightly  open, rocker  arm   is too tight  and holsding  valve slightly  open  and finally,  a burnt  intake valve valve allowing  combustion gasses  to  blow back.

Most  likely  is a timing slip  or  valve  lash on the  intake valve is too tight .

 

  • Like 2
  • 3 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Coyote251
      I'm trying to help a buddy out with his bike (he's not really on the internet or familiar with these forums) and I'll admit that I am not super familiar with the transmission and clutches in these bikes. I owned a Brute a few years ago, but never had an issue like this that I had to troubleshoot.
      So basically my buddy bought a group lot of 650's to build one good bike out of. He got it all put together and has it running but when he pushes on the throttle the clutch doesn't engage till the RPM's are quite high and even when its moving it doesn't really speed up, almost seems like its in "limp mode". He's tried 2 different transmissions so I don't think that's the problem. 
      Is there any adjustment on the clutch engagement? Anything else I can tell him to look at? Let me know if you need anymore information if you think you can help.  
    • By Tinkeringreg
      Hi my name is Greg and I just acquired a free 2000 yamaha kodiac 400 4x4 with the ultramatic transmission that does not run. I plan to get it going and use it around my property

    • By DPDISXR4Ti
      I hadn't driven my Kodiak for a two months, and since it was low on fuel, the first thing I did was filled it up to maybe 7/8 full. Getting ready to start it, I rotated the fuel selector switch to "on" and within seconds I smelled and saw fuel dripping onto the floor. I quickly turned it off and the fuel gradually stopped - I can repeat this.
      The fuel is flowing from the hose that is connected to the bottom of the carb, and routes around to the left side toward the wheel well. Any idea what's going on here? It ran fine the last time I had it out.
      Thanks...
    • By carkivey3
      i just picked this up. was told ran fine but overheating issues led to replacing head gasket and head. has not ran since. he is not a mechanic but helped someone else who he could not get back to finish job, got aggravated and put up for sale. i was thinking timing issues. i have 110-120psi on all 3 cylinders so i think valves are correct. dont know about distributor yet. however i have no spark. i have no power going to ignition coil. tried to follow white wire but gets lost in wire harness. does anyone have a wiring diagram? can anyone tell me what conditions have to be met before starting. motor turns over so i would think all safeties are met but you never know.
    • By kaidella
      Bought 4 wheeler for kids. Used to run and soon as it was put in gear it died. I have put new carburater, new plug and battery. The neutral light won't come on. I replaced the solenoid, then the positive battery cable and today put new relay assembly on. Still no neutral light. Not getting any juice and I don't know why.
×
×
  • Create New...