Quantcast
Jump to content

Recommended Posts

Posted

Boondockers Nitrous Kit- $650 OBO shipped.

This is a Boondockers nitrous kit that i paid $850.00 for and I only used it at 2 trips to the dunes. It is a fun toy to have, i beat banshees and raptor 700's with no problem. I have a water temp. gauge and the motor never got any hotter than normal when I would squeeze.

My method was when I would shift into third I would hit the button for about 2 seconds and then again when I hit fourth. I was usually far enough ahead that I really didn't need to hit it after fifth gear. Like i said it was really cool to have, don't really want to get rid of it but my girlfriends quad needs a new front end. I will miss it but my girlfriends safety is a little more important to me than all the looks i would get with the nitrous bottle hanging in front of the quad. My quad just has a pipe, k & N with no lid and re-jetted. I will include the k & n filter so you don't have to worry about drilling the hole in the back of it for the manifold. ( The hose coming from the bottle to the solenoid is steel braided.)

NEED THIS THING GONE. IF YOU NEED PICS EMAIL ME AT [email protected]

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gtc4d
      I recently purchased a raptor 80 for my grandson for  christmas. I am trying to make sure it is running properly. i have rebuilt the carb and adjusted the carb idle then the mixture to middle of where it runs rough and it runs great for about a min or 2. then it stalls out. I can usually choke it and it will start so i feel it is lacking fuel. the fuel shutoff valve has been changed and i checked it for good fuel flow.  any ideas of what to check next. I am planning to vfy fuel float height tomorrow. I visually checked it by turning carb upside down when i had it apart and it looked level. any ideas are appreciated. 
       
      Thanks.
      Todd
    • By ButchM
      Hisun 700 EFI. Replaced TMAP sensor had broken off . Fuel pump pressure 41psi. The only way I can keep it running (and runs fine) is to close off fuel return line. 
    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
    • By jordan_ATV
      I got a 2005 350 Raptor Special Edition and I'm dealing with a no start issue; the weirdest thing is when I'm cranking it fires and slows down showing signs of pre firing, smoke shoots out the carburetor every time it sparks. every electrical part (CDI, Rectifier, Stator, Coil) has been swapped out from previous owner, the top end of the engines all new and I cleaned the carb out, anyone got any ideas or similar problems, also is it possible to have a bad spark timing
    • By stealthbu
      cost to overhaul trans in polaris 330 
       
×
×
  • Create New...