Quantcast
Jump to content

Recommended Posts

Posted

I disassembled everything to remove carb and replace. My problem is there's a small plastic tubing that runs from top of tank to somewhere but, the other end came loose but I don't know where it goes. I know I have the hose on the gas cap but, the other one has me baffled the service manual doesn't show. Any help would be appreciated.image.gif.559f8eb22172fe78bebe836373ebd3e5.gif 🙂

Posted

The hose in question is the one that's pushed into the groove on top of the tank. I'm thinking, it might serve the same purpose as the one coming out of the gas cap. Any thoughts on that? I'd just hate to put it back together and find out later, it had an important purpose as I'm in no hurry to take this all apart again LOL!20230531_154606.thumb.jpg.2d6bc4dcb1d43ee962ddca89e019795e.jpg20230531_154548.thumb.jpg.75b2635fdd3902ee3b6dc237ec011f31.jpg

  • Solution
Posted

Correct, vent/ overflow , don't like it much , if you fill the tank too full fuel will come out this hose, it just kind of hangs down by the frame. kind of annoying when trailering with a full tank

  • Like 1
  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By kingkw
      I have a Harbor Freight tire changer. I could not get the tires off the rim.
    • By ButchM
      Hisun 700 EFI. Replaced TMAP sensor had broken off . Fuel pump pressure 41psi. The only way I can keep it running (and runs fine) is to close off fuel return line. 
    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
    • By GERONAMO308
      Hi all, does anyone know what type of plastic is used for making ATV fairings.
      In particular Suzuki Quadrunner 1992, if i cannot get a plastic for it in Red for the rear i will attempt repair.
      I have a King Chrome plastic welding kit, however you need to know what type of plastic you are welding.
      Any advice would be greatly appreciated. 
    • By tds7
      Do any have any experience replacing 2001 Big Bear 400 Front Differential Input Shaft bearing and seal. Getting ready to buy one but the seal and bearing are bad. Any help would be appreciated. 
       
       
×
×
  • Create New...