'07 Yamaha grizzly 350, 2wd gear oil

[Louznmemind]

Can someone please tell me the fill point on the drive axle? '07 Grizzly 350, straight rear drive, not independent. Thanks 

[Gwbarm]

There should be 2 plugs a drain plug(lower) and a fill plug(upper), take the top plug out(fill plug) fill it until it just runs out the hole put the plug back in.

[jen]

That's a nice looking Grizzly...probably low hours.  

[Louznmemind]

35 minutes ago, Gwbarm said:

There should be 2 plugs a drain plug(lower) and a fill plug(upper), take the top plug out(fill plug) fill it until it just runs out the hole put the plug back in.

Thank you brother, some things I've found said that and others said not all the way because it would build too much pressure. I tend to overthink, especially when I see conflicting info. Lol

46 minutes ago, jen said:

That's a nice looking Grizzly...probably low hours.  

It's extremely nice, it actually belongs to an elderly couple I've known most of my life. They bought it new in '07, never been abused and always garage kept. Most likely never seen full throttle until I've been test riding it. Lol

[Gwbarm]

There should be a vent line coming off the transfer case, but if you can stick your finger in the hole and touch fluid you are ok.

[jen]

Hmmm..?