-
Similar Forum Topics
-
By Jdeaton011989
Hi all. I have a timberwolf 250 2nd that will not start.. I thought it was out of time bc the guy I got it from said it just quit on him. The tensioner had a nut welded to it and it was like2 teeth off. I installed new tensioner and chain and it still will not start. It has fire and it will not hit off brake cleaner. It has compression. Haven't put a gauge but I'm sure it will crank and run with what it has. I double checked my work and it's still in time. Spot on. Both valves move. I'm about to put a feeler gauge on them and I'll cone back but other than that any ideas?
-
By davefrombc
1992-98 Yamaha YFB250 Timberwolf 2WD service manual
View File Service/Repair manual 1992-98 Yamaha YFB250 Timberwolf 2WD
Submitter davefrombc Submitted 08/06/2017 Category Yamaha ATV
-
By Tim Keiper
I know this is long shot but, would anyone know where I can find a good used or new original carb for a 2000 YFB250 Timberwolf 4x4.
Every Yamaha dealer I look at on line, it says not available. I have tried 2 aftermarket carbs, and they suck, I would like to find a used original if possible.
And I have another question. Everyone says about Chinese aftermarket stuff is junk, Where does the aftermarket stuff come from when the original in from China ????
-
By exalrod
Hello All !
I am looking for a service manual and wiring diagram for a 2005 50cc Polaris Predator 4 wheeler.
Could anyone help with this?
-
By Tim Keiper
1st problem, Does anyone know where I can find a stock carb for my Timberwolf, I have tried two different aftermarket carbs and they both suck. The machine runs great until it gets good and warm, then it keeps stalling unless I feather the throttle. it will even stall while I'm trying to go from 1st to reverse or vise versa. I took it to a buddy of mine who is a bike mechanic for years, and he told me try to find a factory carb. When I look online from dealers it says "NOT AVAILABLE" anyone have any suggestions ?
2nd, The small tab on the rear axle for towing is to short for even pulling my small yard trailer, I can't even turn a little bit and hit hits. I tried making an extension which worked great as far as length, but it bends the tab and then the extension drags the ground. I have an idea of what to do to fix it, but wanted to see if anyone else has had this problem and see how you solved it.
-

Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.