Quantcast
Jump to content

Recommended Posts

Posted

Hi! I hope someone can help me. I have a 2001 Honda Rancher that is leaking oil at the crankcase vent hose in the air box. Does anyone have any suggestions. I read in other posts that it could be piston rings but there does not seem to be any power loss or excess smoke. If I do a compression check what should it read? Thanx for your help.....

Posted

Yes, I have a Clymer that reads 667 kPA (97PSI) @450 RPM. But how does that relate to using a comp. guage stuck in sparkplug hole while it is not running? Please excuse my ignorance as I have never had to use a comp. guage

Posted

Well what you need to do is: screw in that compression tester in place of the spark plug and then crank the engine about 4-5 times (it won't start without the plug). At the same time you should be looking at the gauge to see what the max psi is. That is how you get your cylinder compression reading.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By umax33
      i just got a 1986 honda trx 200 and the reverse and neutral lights don't work, i looked in the service manual and it says to remove two screws and the cover comes up and you can check the bulbs, the book does not show the two screws and i can't see them.Does anyone know how to get to the screws to check the bulbs. i will appreciate any help i can get...thank you
       
    • By docdoug72
      Has anyone had a suzuki 230 quad lock the engine up?  Its a well maintained bike, it locked up when my son was riding it. Pulled the plug, it has connected with the piston. I'm thinking the con rod let go.  I don't have a service manual.  Does the engine need to come out to check further?
    • By Atomusthenes
      I would appreciate being pointing in the correct direction for a wiring diagram and or schematics of the 88 Honda FourTrax 300 4x4 if anybody has any knowledge of how to test the ignition system stator and CDI I don't know if the voltage regulator probably and also the FCU I put a new ignition in it it is a cheap aftermarket one doesn't have the correct plugs but has the correct wiring scheme I get power  the neutral light comes on and the oil light stays on it turns over but I have no spark
    • By Atomusthenes
      This topic is being opened to discuss the feasibility of forced induction on small engines.
    • By BuckBilly
      I like to ride in wooded and grassy areas. It takes my mind off the everyday routines and helps me deal with my father's cancer. Also gives me a reason to get involved with forums like this one.
×
×
  • Create New...